Assessments - 2, GPA: 3
(
)
)
|
Facilidade de uso
• Avoid installing the hob above a dishwasher: if this cannot be avoided, place a waterproof separation device between the two appliances. • Depending on the hob you want to install, the cabinet must have the following dimensions (see figure): FRONT SIDE OF HOB SUPPORTING SURFACE 3040UNDERSIDE OF HOB 5 mm min. 20 mm min. 20 mm min. 40 mm COMPARTMENT 5 mm min. 40 mm FAN-ASSISTED OVEN 560 +/- 1 490 +/- 1 48 590 520 560 +/- 1 490 +/- 1 48 574 504 Ventilation To allow adequate ventilation and to avoid overheating of the surrounding surfaces the hob should be positioned as follows: • At a minimum distance of 40 mm from the back panel. • So that a minimum distance of 20 mm is maintained between the installation cavity and the cabinet underneath. • Kitchen cabinets adjacent to the appliance and taller than the top of the hob must be at least 600 mm from the edge of the hob. 18 Fixing The appliance must be installed on a perfectly level supporting surface. Any deformities caused by improper fixing could affect the features and operation of the hob. The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks: • 30 mm thick: 17.5 mm screws • 40 mm thick: 7.5 mm screws Fix the hob as follows: 1. Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob. 2. Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface. 3. For hobs with raised sides: After inserting the hob into its cavity, insert the 4 fixing hooks (each has its own pin) into the lower edges of the hob, using the long pointed screws to fix them in place, until the glass is stuck to the supporting surface. ! The screws for the alignment springs must remain accessible. ! In order to adhere to safety standards, the appliance must not come into contact with electrical parts once it has been installed. ! All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. Electrical connection ! The electrical connection for the hob and for any built-in oven must be carried out separately, both for safety purposes and to make extracting the oven easier. Terminal board On the lower part of the UNDERSIDE OF HOB appliance there is a connection box for the different types of electricity supply (the picture is only an indication and is not an exact representation of the purchased model). Single-phase connection The hob is equipped with a pre-connected electricity supply cable, which is designed for single-phase connection. Connect the wires in accordance with the instructions given in the following table and diagrams: Voltage and Electrical cable Wire connection mains frequency : yellow/green 220-240V 1+N ~ N: the two blue wires together 50/60 Hz L: brown and black together Other types of connection If the mains supply corresponds with ...
Este manual também é adequado para os modelos :Placa - C (1.35 mb)
Placa - X (1.35 mb)
Placa - VRM 641DC (1.35 mb)
Placa - DX (1.35 mb)