#JB10201 PRINTED IN CHINA ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

Consequently, it is not recommended that this tool be used for extended work on any fiberglass material, wallboard, spackling compounds, or plaster. During any use on these materials, it is extremely important that the tool is cleaned frequently by blowing with an air jet. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. 13 MAINTENANCE MAINTENANCE LUBRICATION All of the bearings

If you are confused about any aspect of this machine, DO NOT use it until you have answered all your questions. Serious injury may occur. Like all power tools, there is danger associated with the Model G1033 20" Planer. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this tool with respect and caution to lessen the possibility of operator injury. If normal safety precautions are overlooked or ignored serious personal injury may occur. -26-G1033 20" Planer

SAVE THESE INSTRUCTIONS Work Area Avoid accidental starting. Be sure switch is in the locked or off position before Keep your work area clean and well lit. inserting battery pack. Carrying tools with Cluttered benches and dark areas invite your finger on the switch or inserting the accidents. battery pack into a tool with the switch on Do not operate power tools in explosive invites accidents. atmospheres, such as in the presence of flammable liquids, gases, or dust. Power Remove adjusting keys

The JET JWP-15DX and JWP-15HH have two material feed rates –20 FPM (Feet Per Minute) used primarily for rough dimensioning and 16 FPM to increase the cuts-per-inch to create a silky-smooth surface. A push/pull knob shifts between the feed rates on the fly. The rollers are driven by a gear and chain drive with an automatic chain tensioner, housed in a cast iron case. The gear section runs in an industrial style oil bath for maximum control over long-term wear. The all-metal adjustable feed roller

Tighten the knurled lock knob to secure the blade. 4. Verify that the blade is parallel with the sole— so an even amount of the blade protrudes from one side to the other. —If the blade is not parallel to the sole, loosen the lock knob and adjust the blade as needed. One side will cut more than the other if the blade is not parallel to the sole. To reduce the risk of injury when using this tool: • Usecarewhenhandlingtheplaneblade. Itissharpandcancauselacerations. • Protectyoureyesfromflyingchips

Very easy to use and a must for any chisel owner. It can also be used for plane irons up to 25.8" wide and chisels up to 15.8" wide. If you've tried sharpening blades by hand then you know that this is one tool you must have! Figure 2. g1482 honing guide. H2927—3 Pc. Diamond Whetstone Set Includes extra fine, fine, and coarse grades. Quick, easy and effortless sharpening. no oil lubrication needed. Only requires water. Extremely durable. Figure 3. h2927 3-Pc. diamond Whetstone set. Japanese Wate

Factory adjustments that should be verified: 1. Outfeed Table Height (page 31) 2. Depth-of-Cut Scale (page 32) 3. Fence Stops (page 32) G0526 6" Jointer -21 SECTION 6: OPERATIONS General Your safety is important! Please follow the warnings below during this entire section: Damage to your eyes, lungs, and ears could result from failure to wear safety glasses, a dust mask, and hearing protec- tion while using this machine. Loose hair and clothing could get caught in machinery and cause serious per