It is important that you read this entire instruction sheet to become familiar with this product before you begin using it. Warning: Always wear ANSI approved safety goggles, full face shield, and dust mask or respirator when working with the Wire Cup Brush. Warning: Never exceed the recommended maximum safe speed RPM. 2-1/2” Wire Cup Brush: 12,500 Maximum RPM 3” Wire Cup Brush: 12,500 Maximum RPM Before using the Wire Cup Brush: 1. Inspect the brush and spindle for rust, damage or other ki

All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353. Thank you for choosing a Harbor Freight Tools product! For future reference, please complete the owner’s record below: Model:_ Purchase Date:_ Save the receipt and these instructions. It is important that you read this entire instruction shee

Close the two Doors (H), and place h. the Dome Lid (C) onto the Smoker House Grill. Open the Vent (I), on top of the Dome Lid (C), all the way. NOTE: Let the charcoal completely burn out before emptying the charcoal ash into a metal ash storage container with a tight metal cover. To prevent accidents, let the Smoker 4. House Grill cool completely before emptying, cleaning, or storing. Always store the Smoker House Grill away from flammable materials, and out of children’s reach. Using your Smoke

Use the tool for short periods of time to avoid fatigue and possible accidents. 13. Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified techni

Loose clothes, jewelry, or long hair can be caught in moving parts. Do not overreach. 5. Keep proper footing and balance at all times. Proper footing and balance enables better control of the power tool in unexpected situations. Use safety equipment. 6. Always wear eye protection. Dust mask, nonskid safety shoes, hard hat, or hearing protection must be used for appropriate conditions. Always wear ANSI- approved safety goggles, a dust mask/respirator, and work gloves when using or performing main

All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included. For technical questions and replacement parts, please call 1-800-444-3353. Specifications Blade D

Before attaching this ATV Spreader, 5. consideration must be given to the load capacity of the vehicle to be loaded. Be sure to account for the weight of this Spreader and the weight of the material being spread. Maintain labels and nameplates on 6. the appliance. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement. The warnings, precautions, and in7. structions discussed in this instruction manual cannot cover all possible condition

NOTE: Do not tighten hardware at this time. (See Figure C.) FIGURE CHEX BOLT(32) GEAR BOX & AXLE(39) HOPPER(16) LOCK NUT(24) WHEEL ASSY. FRAME(20) Attach one end of the Frame Braces 4. (31) to the Hopper Frame (30), using two Bolts (33) and two Lock Nuts (24). Then attach the other ends of the Frame Braces, with the Cross Brace (45) positioned between the Frame Braces, to the Wheel Assembly Frame (20), using two Bolts (11). NOTE: Do not tighten hardware at this time. (See Figure D.) FIGURE DLOCK