This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION indicates a potentially hazardous situation which, if not avoided, may result in m

Hd. 1/4"x1/4" 41 S-7186 2 Set Screw - Skt. Hd. 1/4"x1/4" 42 S-6369 4 Carriage Bolt, 1/4"x3/4" 42 S-6369 4 Carriage Bolt, 1/4"x3/4" 43 2FH0687 2 Machine Screw -Rd. Hd.#4-40x5/8" 43 2FH0687 2 Machine Screw -Rd. Hd.#4-40x5/8" 44 S-1101 6 Hex Bolt, 1/4"x1/2" 44 S-1101 6 Hex Bolt, 1/4"x1/2" 45 S-8072 4 Hex Bolt, 5/16"x3/4" 45 S-8072 4 Hex Bolt, 5/16"x3/4" 46 S-7521 2 Hex Bolt, 3/8"x 1 1/2" 46 S-7521 2 Hex Bolt, 3/8"x 1 1/2" 47 S-7744 1 Hex Bolt, 3/8" x 5-1/2" 47 S-7744 1 Hex Bolt, 3/8" x 5-1/2" 48 2F

This information relates to protecting personal safety and preventing equipment problems. It is the responsibility of the owner/operator to inform anyone operating or working in the area of this equipment of these safety guidlines.To help you recognize this information, we use the symbols that are defined below. Please read the manual and pay attention to these sections. Failure to read this manual and it’s safety instructions is a misuse of the equipment and may lead to serious injury or death.

Installation and Operation Econo-Mizer INSTALLATION Use Tables A & B to determine the proper size of fuse protection and the length and size of wiring required. Portable extension cords, if used, should be as short as possible to minimize voltage drop. Cords that are too long, or cords that are made of inadequate wire gauge, can cause the motor to fail. TABLE A (WIRE SIZE) MOTOR 25 FT 50 FT 100 FT DISTANCE 200 FT 982 (1/3 hp-115V) 986 (1 HP-230V) 996 (1-1/2 hp-220V) #18 GA #14 GA #14 GA #16 GA #

center of bin. a. Slingers on pan are set too far out (grain is hitting the wall Grain forms “donut” and bouncing back). a few feet from wall. b. Open slide gate to fill center of bin. c. Spreader model is not adequate for bin size. a. Spreader pan is turning the wrong direction: Pan should turn clockwise when viewed from the top. Grain not getting b. Rubber drive wheel is slipping - replace if badly worn. all the way to wall. c. Spreader is hanging too high in the center of the bin. d. Spreader