Assessments - , GPA: ( )

Instruções de Operação Campbell Hausfeld, Modelo TL1118

Fabricante : Campbell Hausfeld
Arquivo Tamanho: 1.34 mb
Arquivo Nome :

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

2. Place the resin disc in front of the appropriate size pad and push the adapter lock down through the center of the pad and discs. 3. Hand tighten the adapter lockdown, then insert the holding tool into the hole shown in Figure 2. Insert a large screwdriver into the slotted hole on the adapter lock down and securely tighten. DUaL aCTIOn SanDerS Begin sanding with an abrasive grit coarse enough to remove the high spots and any excessive roughness. Follow with a second sandpaper using a grit one to two ranges finer. Continue with successively finer grits until the desired finish is obtained. Do not change from a coarse grit to a very fine grit in one step. In doing so, it is difficult to remove swirl marks that might have been made by the coarse grit abrasive. Always use the finest grit practical for the sanding operation. HIGH SPeeD SanDerS The coarse resin disc is used for removing or smoothing over welds or blending uneven metal surfaces. The most common grit is 36 (Campbell Hausfeld MP3264 discs). Worn or damaged sanding discs may break apart causing serious injury. Always replace discs as needed. aIr HOSe Refer to IN170102AV Air Hose Hookup Installation sheet for hookup specifications. nOTe: It is not recommended to install a quick coupler between the sander and the leader (whip) hose. Use of a whip hose prevents accidental triggering of the tool when pressurized air is connected to the system. In addition, the tool’s vibration wears out quick couplers prematurely. 2 TL0504, TL0518, TL1005, TL1118, PL1551, FHT504, IFT218, PL1504, TL1004 Never carry a Operation (Continued) maintenance tool by the hose or pull the hose to move the tool or STOraGe Using fittings or air hoses which are too small a compressor. Keep hoses away from The air tool must be lubricated before can create a pressure drop and reduce the heat, oil and sharp edges. Replace any storing. Follow the air motor lubrication power of the tool. A 3/8” (I.D.) fitting with hose that is damaged, weak or worn. instructions with an exception to step 4. Run 1/4” NPT threads is recommended. Most the sander for only 2 to 3 seconds so more oil compressors are shipped with a short, 1/4” will remain in the air tool when storing. I.D. hose. For proper performance and more convenience, use a 3/8” I.D. hose. Hoses TeCHnICaL ServICe longer than 50 feet should have a 1/2” I.D. For information regarding the operation or repair of this product, please call 1-800-543 6400. Troubleshooting Chart Symptom Possible Cause(s) Corrective action Tool runs slowly or will not operate. 1. Grit or gum in tool 1. Flush the tool with Campbell Hausfeld air tool oil, gum solvent, or an equal mixture of SAE 10 motor oil and kerosene. If Campbell Hausfeld oil is not used, lubricate the tool after cleaning 2. No oil in tool 2. Lubricate the tool according to the lubrication instructions in this manual 3. Low air pressure 3a. Adjust the regulator on the tool to the maximum setting (If applicable) 3b. Adju...