To install the vacuum tubes: • Secure the upper and lower vacuum tubes together by aligning the raised locking tabs with the raised slots. • Tap tube assembly on ground until the screw holes in lower tube are in the raised slot of the upper tube. Secure with supplied screws. • Depress door tab using a flathead screwdriver and open vacuum inlet door. • Align screw mounts on vacuum opening with screws on vacuum tube assembly. • Turning clockwise, tighten screws on upper vacuum tube to secure to bl

Before use of this product, familiarize yourself with all operating features and safety rules. BLOWER TUBE AND NOZZLE The blower tube and nozzle can be assembled and installed on the blower without using any tools. THROTTLE/CRUISE CONTROL LEVER The throttle/cruise control lever feature allows the user to operate the blower without holding the throttle trigger. To slow the engine, simply push the throttle/cruise control lever forward. ENGINE The blower has a powerful 30cc engine with sufficient p

2-CYCLE FUEL / OIL MIX (50:1) GASOLINE OIL 1 gallon (US) 2.6 oz. 1 liter 20 cc (20 ml) HOT RESTART OF THE ENGINE: . Set the choke lever to the RUN position. . Lock throttle/cruise control lever. . Pull the starter grip and rope until the engine runs. IF ASSISTANCE IS REQUIRED STARTING THIS PRODUCT: Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have. For Help Call: 1-800-860-4050 OPERATING THE BLOWER See F

Specific Safety Rules.........................................................................................................................................................4 Regles de securite particulieres / Reglas de seguridad especificas . Symbols.............................................................................................................................................................................5 Symboles / Simbolos . Features...........................................

Turn the lower vacuum tube clockwise until it snaps into detent and locks. (The dot on the lower tube aligns with the dot on the upper tube when properly assembled.) Lower Vac Tube Rg. 12- INSTALLING THE COMPLETE VACUUM TUBE ASSEMBLY TO THE BLOWER/VACUUM (MODEL 310BVr ONLY) WARNING: Do not install the vacuum tubes while unit is running to avoid serious personal injury. 1. Grasp the assembled vacuum tube firmly with both hands. Turn the tube/adapter clockwise as far as possible to the end of

They should also be included as part of any seasonal tune-up. A WARNING: To prevent serious injury, never do maintenance or repairs with unit running. Always do maintenance and repairs on a cool unit. Disconnect spark plug wire to ensure the unit will not start. FREQUENCY MAINTENANCE REQUIRED REFER TO: Before Starting Engine Fill fuel tank with correct oil and fuel mixture Page 12 Every 10 Hours Clean and re-oil air filter Page 15 Every 25 Hours Check spark arrestor condition and clean Chec

WARNING: Check for fuel leaks. If you find any leaks, correct the problem before using the product. WARNING: A leaking fuel cap is a fire hazard and must be replaced immediately. 12 13 ENGINE SWITCH OPERATION STARTING AND STOPPING See Figures 9 - 10. To start an engine that is cold or has run dry: . Fill the fuel tank, if necessary. Always use the proper oil/gasoline mixture. See Mixing the Fuel on page 12. . Disengage the cruise control lever. NOTE: Do not engage the throttle trigger during the

away. . Wear heavy long pants, long sleeves, boots, and gloves. Do not wear loose fitting clothing, short pants, sandals, jewelry of any kind, or go barefoot. . To reduce the risk of injury associated with objects being drawn into rotating parts, do not wear loose clothing, scarves, neck chains, etc. . Secure long hair so it is above shoulder level to prevent entanglement in any rotating parts. . Do not operate this unit when you are tired, ill, or under the influence of alcohol, drugs, or medic

The California Air Resources Board’s Emission Warranty Parts List specifically defines the emission-related warranted parts. (EPA’s regulations do not include a parts list, but the EPA considers emission-related warranted parts to include all the parts listed below.) Techtronic Industries North America, Inc., will provide any documents that describe its warranty procedures or policies within five days upon request by the California Air Resources Board. EMISSIONS PARTS LIST Emissions parts vary f

1b Fig. 2 Fig. 4 B A E B C B C A D A - adaptor installed in vacuum bag (adaptateur installe dans le sac a debris, adaptador instalado en el saco de la aspiradora) B - raised slot (fente en saillie, ranura realzada) C - raised locking tab (languette de verrouillage en saillie, orejeta realzada de aseguramiento) a - sweeper nozzle (embout eventail, boquilla para barrer ) b - upper blower tube (tube de soufflante superieur, tubo superior de la sopladora) A a - high velocity nozzle with leaf scraper