Assessments - 1, GPA: 5
(
)
)
|
Facilidade de uso
NOTE: Do not connect a “Common” wire this thermostat. Tape up the wire and do not use. Mount Snap open the your thermostat the release tab on the the thermostat. Position wallplate on through large opening. Then level appearance. Mark holes if existing holes Hunter Thermostat holes. Drill holes with 3/16" bit and gently Reposition wallplate to wall, pulling through large opening. Insert mounting screws provided into wall anchor and tighten. 2.) FIGURE 2 14-15Installation Selector Switches The heating system selector switches are located on the Printed Circuit Board. ¦ Heating system selector The heating system selector is Board on the inside of the thermostat. The switch is at “HG” furnace or an oil burner. If you have an electric furnace, test to see whether the heat and expected. Leave the switch in the “HG” thermostat calls for heat, change the switch The system selector has no effect in the cooling mode. NOTE: “HG” position is for gas and most other electric systems having a fan relay. ¦ F°/C° selector (Fahrenheit/Centigrade) Your thermostat is set for F° mode from the factory. In order to change to C° mode, slide the switch to C° and press reset button on the front of the thermostat with a paper clip. The reset button is located near the display. NOTE: Unless reset button is pressed, the thermostat will HE HG C F not change the mode. Connect Wires and Mount Thermostat Cover to Wall Plate ¦ Match and connect the labeled wires to the appropriate coded terminal screws on the mounting plate. (See Figure 3, 4.) Ignore any wires which may be present, but which were not connected to the old thermostat. ¦ Be sure to tighten securely, otherwise could cause problems with ¦ Push excess wire back into hole interference with mounting ¦ Make sure the Function Switch and the FAN-AUTO Switch ¦ Insert the bottom tab Press top of the thermostat (NOTE: Do not force the thermostat onto the wallplate, snap properly, the thermostat may not work.) ¦ Insert the two AA size batteries, marked on the unit. ¦ Switch on the main power. Press the reset button. (See Figure 5.) ¦ The LCD display indicates the current room temperature of your house. If it shows random numbers or partial digits, press the reset button once again. ¦ The installation is now complete. Continue reading Owner’s Manual for complete operating instructions. HEAT OFF COOL AUTO FAN RESET FIGURE 5 WRC RH YG RH RH FIGURE 3 FIGURE 4 Programming 16-17 When you first install in the installation the Reset Button. Start-Up 16-17 When you first install in the installation the Reset Button. Start-Up n The thermostat is preset at the factory to 68°F (n Room temperature is displayed. ¦ Your thermostat batteries will prevent memory loss and avoid reprogramming. Replace batteries as soon as low battery indicator ¦ A built-in timer prevents damage to your air conditioner caused by rapid cycling, by providing a delay of 4 minutes before it will restart. n The thermostat will display room temperature from 32°F to 99°...
Este manual também é adequado para os modelos :Os termostatos - 42999 44050S (455.71 kb)
Os termostatos - 42999 44050S (455.71 kb)
Os termostatos - 44050 (455.71 kb)
Os termostatos - 44050 (455.71 kb)