Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
dados de dispositivos de processamento - HP 4400 Dual Controller Enterprise Virtual Array w/Embedded Switch (261.95 kb)
Facilidade de uso
The appearance of your hardware components might
differ slightly from those presented in this document.
Upgrade the management and controller
software
Replace the management module
1.
Upgrade HP P6000 Command View to Version
10.1 or later on all server-based management
The management module is located on the rear of the
arrays.
chassis, above the controllers.
IMPORTANT:
Be sure that you upgrade
NOTE:
To maintain configuration information,
to the same version that is installed in the
such as IP address, perform this procedure with
new management module.
power on.
2.
Upgrade the controller software to XCS
Removing a management module
11001100 or later.
1.
Unplug the Ethernet cable from the module.
3.
Verify the software upgrade before continuing.
2.
Lift the latch on the module and pull the module
For instructions, see the HP P6000 Command View
out slightly. See Figure 1 (page 2).
Installation Guide and the HP P6000 EVA Updating
3.
Position one hand under the module, and with
Product Software Guide.
the other hand, pull the module out of the
controller enclosure.
Figure 1 Removing a management module
Shut down the array
Use HP P6000 Command View to perform an orderly
shut down and power off the array to be upgraded.
From HP P6000 Command View:
1.
Select System Options.
2.
Select Shutdown System.
3.
Enter the delay time, and then click Power OFF.
4.
Follow the prompts to complete the Power OFF.
NOTE:
When the storage system is powered
off, the controller fault and link LEDs at both the
front and rear of the storage system and the
controller power button are all illuminated
amber. Also, the management module link LED
Installing a management module
is illuminated and the activity LED flashes.
1.
Insert the new management module into the slot
until you hear a click indicating that it is fully
seated.
Remove controller 1
2.
Attach the Ethernet cable to the module.
The new management module has HP P6000
1.
If necessary, label the cables that are connected
Command View 10.1 or later pre-installed.
to the controller. This will facilitate reconnecting
them later.
2.
Disconnect the host port and SAS cables from the
controller.
3.
Remove the controller:
a.
Loosen the mounting latch screw, and then
move the mounting latch to the right. See
Figure 2 (page 3). The controller will slightly
eject from the enclosure.
b.
Position one hand under the controller, and
with the other hand, pull the controller out of
the enclosure.
Page 2
... Este manual também é adequado para os modelos :
dados de dispositivos de processamento - HP 4400 Dual Controller Enterprise Virtual Array (624.58 kb)
dados de dispositivos de processamento - HP StorageWorks EVA4400 Dual Controller Array (624.58 kb)
dados de dispositivos de processamento - HP StorageWorks EVA4400 Dual Controller w/(8) 8Gb SFP/(2) 8Gb Embedded Switch (624.58 kb)
dados de dispositivos de processamento - HP StorageWorks EVA4400 Dual Controller w/Embedded Switch (624.58 kb)