Plug of installed refrigerator shall be always accessible. o Care for external cable * Hold the plug, not the electric cable, when unplugging the refrigerator. * Ensure that the electric cable Is not trapped by the refrigerator. Do not step on the cable. * Avoid damage to the electric cable when moving the refrigerator. Damaged electric cable When the electrical cable is damaged or worn, turn off the refrigerator and consult to an authorized service agent for replacement. >T,' \/s

Contact the local distributor If shortage is found. 3. Ensure that the refrigerator is properly located. (See section "Location') 4. Clean the refrigerator before using. (See section "Cleaning") 5. Time lapse before power supply Connect the refrigerator to power source at least 30 minutes after the refrigerator is sited and cleaned. A Caution: After unpacking, write down the model and manufacture number of the refrigerator on the Warranty Certificate which will be required if technical ser

After following these initial directions, please review the entire Use & Care Guide, to familiarize yourself with the more advanced features of your air purifier Basic Operation of the Air Purifier: 1. Take the air purifier out of the box and remove the clear plastic protective bag. Place the unit on a firm level floor or table. 2. Before turning on the air purifier, you need to confirm that the filters are firmly in place and have not become loose during shipping. To check the filters, first

When using this appliance, always exercise basic safety precautions, including the following: 1. This air purifier is designed for use on a flat level floor and may not work properly on an uneven floor. ALWAYS place the air purifier on a firm level floor. ALWAYS place the air purifier at least six (6) inches away from heat sources such as stoves, radiators, or heaters. 2. Place the air purifier in an area that is out of reach of children. 3. Before using the air purifier, extend the power c

This is a safety feature. 8. Finally, reset the Pre-Filter Life Counter by pressing the {^) key for 2 seconds. The Pre-Filter Counter will return to 0%. 10 English Changing The HEPA filter When the filter exceeds 8000 hours (approximately 1 year of use), the Filter Life Counter will display 100% life used and the Filter indicator will flash. This is a reminder that you should check the filter and replace if necessary. The proper time to change the filter depends on usage and the environment

Do not reduce the recommended tubing size. CONDENSATE REMOVAL THIS APPLIANCE EMPLOYS A DRAW-THROUGH COIL, THEREFORE A TRAP MUST BE INSTALLED IN THE DRAIN LINE(S) TO ALLOW FOR PROPER CONDENSATE DISPOSAL. The condensate trap must not be the "running" type, or "R" type. A "P " trap is required. The total workable height of this trap, in inches, must exceed the total negative pressure, in inches of water, as measured in the return duct. UNIT DRAIN CONNECTION FLEXIBLE TUBING-HOSE OR PIPE A POSITIVE 2

WARNING CARBON MONOXIDE (REFERED TO AS CO) CAN CAUSE PERSONAL INJURY OR DEATH WARNING FAILURE TO FOLLOW THESE INSTRUCTIONS, LOCAL CODES OR NATIONAL CODES MAY CAUSE FIRE, EXPLOSION, ELECTRICAL SHOCK, PERSONAL INJURY OR PROPERTY DAMAGE. FOLLOW ALL LOCAL CODES. IN THE ABSENCE OF LOCAL CODES REFER TO : NATIONAL ELECTRICAL CODE NFPA 70 NFPA 90A & 90B UNIFORM MECHANICAL CODE READ THESE INSTRUCTIONS COMPLETELY BEFORE ATTEMPTING TO INSTALL OR SERVICE THIS APPLIANCE. ONLY FACTORY AUTHORIZED KITS OR ACCES