Assessments - 1, GPA: 5 ( )

Fabricante : Electrolux Arquivo Tamanho: 894.87 kb Arquivo Nome : Língua de Ensino:

Important! Risk of burns. Open the door with due care when the appliance is hot. 4.3.7 STOPPING THE COOKING CYCLE When the set time has elapsed the cooking cycle will stop automatically and the appliance's audible alarm will emit a continuous beep. Open the door and remove the product. Important! Risk of burns. Open the door with due care when the appliance is hot. Note: - The audible alarm can be muted by performing any operation on the control panel or by opening the door. To stop the cooking cycle manually press the cycle Start/Stop button and keep it pressed for two seconds. If this button is pressed for less than 2 seconds it will produce no result. To repeat the last cooking cycle with identical parameters press the Start/Stop button again. 4.3.8 MANUAL CYCLE (CONTINUOUS COOKING) Manual cooking cycles can be set by excluding the timer. Follow the instructions in heading 4.3.2 SETTING THE COOKING TIME until the display shows the word "cont", i.e. continuous cooking mode. In this case the cooking cycle must be stopped manually by holding down the Start/Stop button for two seconds or by switching off the oven. 22 USA 5938 035 4.3.9 UTILITIES - Switch on the oven by pressing button I. - Set a cooking cycle for the following UTILITIES: UTILITIES with cycle presetting; this is not necessary for the other utilities as they are already specific cycles. - Press button U (UTILITY): U (UTILITY) - The green UTILITY LEDs will light up and one will be flashing. E.g.: UTILITY selected (flashing GREEN LED) - Turn the knob clockwise or counter clockwise to select the utility required - the relative LED will flash (flashing GREEN color). - Press button U until the flashing LED relative to the UTILITY selected changes colour (flashing ORANGE color). - Wait a further 5 seconds for the LEDs relative to the selected utilities to illuminate steadily (steady ORANGE color). - Finally, start the cycle by pressing the START/STOP button. A complete description of the different UTILITIES available is included in heading 3.4 SPECIAL COOKING MODES (page 20). Note: If the UTILITIES are not used for 7 seconds they are automatically cut out, signalled by the relative button switching off. - To cancel one of the following preset UTILITIES (ORANGE steady): press the U button and turn the knob to select it so that it flashes (ORANGE flashing). Press the U button again so that the UTILITY changes colour (GREEN flashing) and is thus cancelled. - To cancel the other UTILITIES set another cooking cycle. In case of cycle already started, stop it, keeping the START/ STOP button pressed for 2 seconds before cancelling the UTILITY. 4.3.10 COOKING WITH TWO PHASES IN AUTOMATIC SEQUENCE (LEVEL C ONLY) Level B ovens allow the execution of cooking cycles composed of two sequential phases. For example: - Phase 1: - air-convection 200°C - probe 70°C - Phase 2: - mixed cycle 220°C - 40 minutes The oven switches automatically from phase 1 to phase 2. To set a two-phase cycle proceed as follows: 1) Switch the oven; 2) Set the desired cooking mode, oven chamber temperature, and cooking time (or, alternatively, core probe temperature) as described in this handbook. 3) Press the "PHASE" button: Phase 1 (I) LED Phase 2 (II) LED the phase 2 LED switches to RED (active phase) while the phase 1 LED is GREEN (inactive phase); at the same time the cooking modes button LEDs start flashing again to request a new setting for phase 2. 5) Select: - phase 2 cooki...

Baixe o seu

Para fazer o download, introduza 2 dígitos :