While these settings are loaded, the COMPARE key’s LED blinks and “COMP” appears in the LED DISPLAY. Press the COMPARE key again to return to edit mode and store your changes. 16 To enter SETUP mode, press the SETUP key. In setup mode, you can access the parameters shown below the four EDIT CONTROLs. For more information about SETUP mode, see chapter 3.6. 1. INTRODUCTION VIRTUALIZER PRO DSP2024P To change a parameter’s value, rotate the JOG WHEEL. To increase the value, turn the wheel clockwise.

It’s an allrounder with so many features that you hardly need any other equipment. Use it as a guitar combo to deliver 2 x 60 Watts stereo with internal or external loudspeakers. However you use your V-AMPIRE, you will always profit from its enormous flexibility. So enough talk: Nothing will convince you more than what you actually hear and feel when you play your V-AMPIRE. But ... 1.1 ... before you get started Your V-AMPIRE was carefully packed at the assembly plant to assure secure trans

(42) Use the TALK TO AUX 1/2 switch to activate the built-in talk- back microphone. Its signal is sent to the AUX SEND jacks 1 and 2. Keep the switch pressed while you’re speaking. (43) This is the built-in talkback microphone. 2.6.2 Phones & control room Fig. 2.18: Phones/control room section (44) The PHONES/CTRL R control adjusts the volume of the headphones connected to the PHONES/CTRL ROOM OUT jack (see (46)). If you have an active monitor speaker or power amp connected here, you can also co

So, aux send buses are not the best solution here. Instead, dynamic processors and equalizers are inserted into the signal path. Once processed, the signal then re-enters the mixing console at the same point where it left. Signal interruption only occurs if a plug is inserted into the corresponding jack (1/4" stereo plug: tip = signal output, ring = input). All mono input channels are equipped with insert points. They can also be used as pre-EQ direct outputs, without signal flow interruption. F

EURODESK Overview.................................................6 3. Input/Output Channel................................................6 4. Inserts..........................................................................8 5. Subgroup and Direct Outputs...................................9 6. Master Panel.............................................................10 7. Connections...............................................................13 8. The Patchfield..............................

The world’s first DANALOG PRACTICAL APPLICATIONS ® Recording Benefits of the DDX3216 16 high-grade 24-bit converters and 32-bit internal processing for highest dynamic resolution. There is no need to leave the digital domain after the initial A/D conversion, as no additional A/D and D/A conversion stages are required. Thus, maximum audio quality is retained. The busses allow you to record 16 signals at the same time. Along with the four multi outputs, this gives you 20 channels for simultaneous