Campbell Hausfeld’s warranties are void in the event of misapplication and assumes no responsibility for any resulting loss. Specifications Maximum pressure: 150 PSIG (10 bar). Maximum temperature: 125°F (52°C). Installation Disconnect power and release all pressure from the system before attempting to install, service, relocate or perform any maintenance. 1. The air cleaner/dryer should be located as close as possible to the air tool or spray gun. 2. A shutoff valve should be installed before t

General Safety Information This manual contains safety, operational and maintenance information. Read this manual and understand all safety warnings and instructions before operating the nailer. Contact your Campbell Hausfeld representative if you have any questions. The operator of this nailer must take the necessary precautions to prevent unsafe conditions outlined in this manual from occurring. The operator is also required to read and understand this instruction manual and all safety warning

6. Keep operation area clear of all persons. 7. Do not overreach or stand on unstable support. Keep good footing and balance at all times. 8. Follow the maintenance instructions specified in the manual. 9. This product shall be connected to a power supply receptacle protected by a ground fault circuit interrupter. Electrical shock hazard. . NEVER direct water spray toward the power washer or any electrical outlet connection. . NEVER operate the power washer during thunderstorms, or in the rain.