. . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Tools and Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Location Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Water Supply Requirements . . . . . . . . . . . . . . . . . . . . . . . . . 4 Electrical Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation Instructions .

Table of Contents/Table des matieres .......................................................................................... 2 FOR THE WAY IT'S MADE. e Model/Modble KUDS01FK 8269909 TABLE OF CONTENTS TABLE DES MATIERES DISHWASHER SAFETY .............................................................. 3 Before Using Your Dishwasher .................................................... 4 PARTS AND FEATURES ............................................................ 5 START-UP GUIDE ..............

2. Secure the attaching tabs to the cabinet using #8 Phillips head screws. NOTE: Before securing the dishwasher, confirm that the chassis is still properly aligned. 6 3. Pull one of the bottom drawer runners all the way out. Make sure the latches on the back of the drawer runner are facing forward. 4. If the bottom drawer was rotated, rotate the drawer to unwind the hoses and then put the drawer on the extended runner, making sure the hoses are looping upward. 5. While holding on to the drawer,

The pre wash and main wash sections both have inside fill line markings. The pre wash section has one marking which represents 1 tsp (5 mL). When it is full, it holds 2 tsp (10 mL). The main wash section has two markings, the lowest mark indicates 2 tsp (10 mL), the middle mark 4 tsp (20 mL), and when it is full it contains 6 tsp (30 mL). NOTE: The detergent dispenser is designed for use with powdered detergent. Liquid and tablet detergents are not suitable to be used in the dispenser. (Posts in

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Tools and parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Location Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Drain Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Water Supply Requirements . . . . . . . . . . . . . . . . . . . . . . 5 Electrical Requirements . . . . . . . . .

Call t_ KitchenAtdConsumerAssistance Centerwhen you: Havequestionsaboutdishwasherinstallationor operation. 1_ Needtoobtainthenameand numberofa KitchenAid-authorized service company, Important: • Installer:. LeaveInstalLationInstructions withthe homeowner. • Homeowner: KeepInstallationInstructionsfor future reference. • Save InstallationInstructionsfor localelectricalinspector's use, PartNo. 9743822 Rev,C Piece n° 9743822 R_. C In_on s_s cont fmm _ s If connecting dishwasher with power supply cor

Do not clean the dishwasher interior until it has cooled. You may want to wear rubber gloves. Do not use any type of cleanser other than dishwasher detergent because it may cause foaming or sudsing. To clean interior Make a paste with powdered dishwasher detergent on a damp sponge and clean. OR Use liquid automatic dishwasher detergent and clean with a damp sponge. OR See the vinegar rinse procedure in “Spotting and filming on dishes” in “Troubleshooting.” NOTE: Run a Normal cycle with detergent

electrical supply. Use copper wire only. A time-delay fuse or circuit breaker and separate circuit is recommended. If using a Hot Water Accessory Tank and/or a garbage disposer, a separate 120-volt, 60 Hz, AC-only, 15- or 20-amp fused electrical supply is required for each devise. Water: For dishwasher, a hot water line with 20-120 psi (138-827kPa) water pressure. Water temperature must be minimum 120°F (48.9°C) at dishwasher. Use 3/8" O.D. copper tubing with compression fitting is recommended