Log:
Assessments - , GPA: ( )

Instruções de Operação HP, Modelo HP 4400 Dual Controller Enterprise Virtual Array w/Embedded Switch

Fabricante : HP
Arquivo Tamanho: 163.11 kb
Arquivo Nome :

Língua de Ensino: en

O documento está colocado, por favor, espere
Baixe o seu Fechar
O documento está colocado, por favor, espere
Baixe o seu Fechar


por este dispositivo também tem outras instruções :

Facilidade de uso








• Check status using HP P6000 Command View:
2.
Slide the power supply into the enclosure until a click is detected
1.
In the navigation pane, select Storage system > Hardware >
when fully seated.
Controller Enclosure.
2.
In the Controller Enclosure Properties window, select the Power
tab. The status is displayed in the Power Supplies section. An
operational state of (Failed) would indicate a fault that may
require a replacement.
3.
To help identify the correct enclosure in the rack, select Controller
Enclosure in the navigation window, and then click Locate >
Locate On in the content pane. This causes the blue UID indicator
to blink on the controller enclosure.
• Check the power supply status LED.
• Green—Normal operation
• Amber—Fault condition
• Off—Module not fully connected or not receiving AC power
Figure 3 Installing a power supply
Removing a power supply
.
3.
Connect the AC power cord to the power supply.
4.
If you removed the PDM power cords to access the power supply,
NOTE:
reinsert the cords into the PDM now.
Due to the length of the controller enclosure, replacing the power
supply may require that you remove one to three power cords
from the power distribution module (PDM) mounted on the side
Verifying proper operation
of the rack to ensure adequate clearance.
After replacing the power supply, check the following to verify the
component is operating properly:
1.
Disconnect the AC power cord from the power supply.
2.
Move the mounting latch to the left (1, Figure 2), grasp the handle,
NOTE:
and pull the power supply out slightly.
Wait approximately 30 seconds for the system to check the
3.
Position one hand under the power supply, and with the other hand,
component status.
pull the power supply out of the enclosure (2, Figure 2).
• Verify the green LED is lit. If not, try reseating the power supply.
• From HP P6000 Command View, navigate to the component as de-
scribed in the Verifying component failure section, and check the
status. It should be
(Good).
Figure 2 Removing a power supply
.
Installing a power supply
1.
Remove any connector cover that may be protecting the AC power
connector on the new power supply.
Page 2

...

Este manual também é adequado para os modelos :
dados de dispositivos de processamento - HP 4400 Dual Controller Enterprise Virtual Array (163.11 kb)
dados de dispositivos de processamento - HP EVA P6350 450GB 10K SAS Field Starter Kit (163.11 kb)
dados de dispositivos de processamento - HP EVA P6350 450GB 10K SAS FIO Starter Kit (163.11 kb)
dados de dispositivos de processamento - HP EVA P6350 900GB 10K SAS Field Starter Kit (163.11 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias