Log:
Downloads : 0   Arquivo Tamanho: 78 kb   Fabricante : Bosch  
Categoria : Fans
@name

Stainless Steel Surfaces: Wipe and dry stainless steel in the same direction as the grain. Avoid using too much pressure, which may mar the surface. To remove finger prints and give added shine, use spray cleaners such as Stainless Steel Magic®. Do not allow any cleaning compounds to remain in contact with stainless steel for extended periods. Filters The hood has removable aluminum filters that must be cleaned when they collect grease. The filters can be cleaned with soap and water or in the di

Downloads : 0   Arquivo Tamanho: 78 kb   Fabricante : Bosch  
Categoria : Fans
@name

IMPORTANT: Save these instructions. INSTALLER: Please leave these instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. Important Safety Warnings A special message to our customers: Thank you for buying a Bosch Ventilation Hood. Please take the time to read and understand this entire booklet before using your new appliance. We hope that the information in this manual will help you easily operate and care for your hood with years of satisfaction.

Downloads : 6   Arquivo Tamanho: 82 kb   Fabricante : Bosch  
Categoria : Fans

Downloads : 8   Arquivo Tamanho: 82 kb   Fabricante : Bosch  
Categoria : Fans
@name@name@name@name

I wahlen. • Fur die Thermostatregelung drehen Sie den Knopf im Uhrzeigersinn, bis die hei.e Luft die gewunschte Temperatur erreicht. Sobald die gewunschte Raumtemperatur erreicht worden ist, drehen Sie den Knopf langsam in die entgegengesetzte Richtung, bis die Leuchtanzeige verloscht. Der Thermostat wird es automatisch aus- und einschalten und dabei die Temperatur auf den gewahlten Werten halten. • Die leuchtende rote Leuchtanzeige zeigt, da. die Heizung in Betrieb ist. • Die Drehrichtung des V

Downloads : 4   Arquivo Tamanho: 82 kb   Fabricante : Bosch  
Categoria : Fans

Downloads : 4   Arquivo Tamanho: 132 kb   Fabricante : Bosch  
Categoria : Fans
@name

For vertical discharge, remove the knockout in the top of the hood. 3. Install Internal Blower (DAH95 models only) If your hood is already equipped with a blower, or you will be using a remote blower, proceed to Step 4: Install Transition (next page). 1. Remove rear filter rail. 2. Remove blower control wire cover. 3. Remove J box. 4. With hood standing on its back wall, place blower in center of hood. 5. Screw 6 screws (3 on each side) through mounting plates. See Figure 2. Figure 2 - DAH95 mod

Downloads : 8   Arquivo Tamanho: 132 kb   Fabricante : Bosch  
Categoria : Fans
@name

INSTALLER: Please leave these instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. Read and Save These Instructions Installation Must Comply With all Local Codes Please Read Entire Instructions Before Proceeding WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. (Bosch Service: 800-9442

Downloads : 13   Arquivo Tamanho: 144 kb   Fabricante : Bosch  
Categoria : Fans

Downloads : 0   Arquivo Tamanho: 144 kb   Fabricante : Bosch  
Categoria : Fans

Downloads : 6   Arquivo Tamanho: 173 kb   Fabricante : Bosch  
Categoria : Fans
@name

— Fig. 4. B~] 10 Wall mounting • Fix the drilling template to the wall. • Make 3 0 8mm holes in the wall 2 at points I, 1 as desired at points L. • Insert the three 0 8mm expansion plugs into the wall. • Insert 2 5x45 screws at points I but do not tighten them completely. • Adjust the unit so that it is positioned at a right angle to the wall by turning the two support screws G. • Fit the hood into holes I, tighten the 2 screws. • From inside the hood, insert the third 5x45 screw into





categorias