BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.) Connect to RED siren wire from the Siren in the engine compartment. WHITE WIRE: PARKING LIGHT OUTPUT: +12V or (-) Negative Ground (Jumper Selectable) Connect to switched +12V parking light wire at back of light switch. If this is not possible, connect directly to one of the parking lights at the front of the vehicle. If your vehicle requires a (-) Negative Ground signal to activate the parking lights, then you have to move the jumper located on the circu

This booklet contains the information necessary for installing, using, and maintaining your alarm system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below. *IMPORTANT INFORMATION: Primary and Optional Features: -PRIMARY: These are features that must be connected in order for the system to operate properly; i.e. the Siren, +12V Power, Ground, Door pin, Flashing lights, LED/Valet Pod etc. -OPTIONAL: These are features

DISARMING BUTTON 2 BUTTON 1 BUTTON 1 + 2 = BUTTON 4 (NO BUTTON 3 WITH WATCH) To disarm the alarm and unlock the doors, press the #2 Button on either transmitter. You will hear 2 siren chirps and the lights will flash twice. The in-dash LED stops flashing dome light turns on. (Optional) If the alarm is tripped, then the #2 Button will have to be pressed twice. The first press will reset the trigger and the second press will Disarm. OPERATION OPERATION ALARM CYCLE RESET If and when the alarm syste

(Toggle not included) See programming option #13 on page 10 to enable this type of starter disable. CUTSTART WIRESTARTERORANGEIGNSWITCHORANGEORANGEN/ CN/ OCOMNOTE ALIGNMENT OF PLUGN/ C = NORMALLY CLOSEDNORMALLY CLOSED STARTER DISABLE (DEFAULT) CUTSTART WIRESTARTERORANGEIGNSWITCHORANGEORANGEN/ CN/ OCOMNOTE ALIGNMENT OF PLUGN/O = NORMALLY OPENHIDDEN TOGGLESWITCH**JUMPER # 7 MUST BEREMOVED! ** (NOT INCLUDED) NORMALLY OPEN STARTER DISABLE (OPTIONAL) Text Box: 8 SYSTEM WIRING DIAGRAM 873087308730IGNI

This booklet contains the information necessary for installing, using, and maintaining your 2004TW1 or 2004DC alarm system. any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below. This installation book is designed for the installer or with an existing understanding of automotive systems, along with the ability to test and connect To ease installation, we suggest that you READ THIS MANUAL before beginning your This book is pr

2X then 12X 1X Green / 12X Orn. SILENT ARM #4 (Slnt) Press & Release 1X then 4X Orange / 4X SILENT DISARM #4 (Slnt) Press & Release 1X then 2X Green / 2X AUX #1 #3 (Aux.) Press & Release 1X then 3X NONE AUX #2 #4 (Slnt) Press/hold 2 sec. NO PAGE BACK Orange/Blinking Door Violation 1 Long / 2 Short Red / 3X Hood/Trunk Violation 1 Long / 2 Short Red / 3X Ignition Violation 1 Long / 4 Green / 5X Sensor Violation 1 Long / Yellow / Text Box: Text Box: Text Box: 15 OPERATION ACTIVE ARMING To arm the a

Use the TACH FINDER feature if needed. TACH FINDER FEATURE: The Tach Finder mode can assist you in locating or verifying a Tach source for your installation. Follow the Tach Finder steps below to locate signal. The unit will begin to flash the parking lights if you have the White/Red wire connected to a valid tach source. If lights do not flash, then try another wire until you locate a tach signal that will cause the Parking lights to flash. NOTE: On vehicles equipped with daytime running lights

*60 Sec.* 12 Door Lock Pulse Time 3 Sec. *0.75 Sec.* 13 Double Unlock Pulse 2 Pulses *1 Pulse* 14 Lock After Remote Start/Abort OFF *ON* 15 NOT USED N/A N/A 16 Timed Crank or Tach Monitor Pre-Set *Tach Monitor* 17 Blue/Black Wire Function AUX #2 *(-) Run / Ignition* 18 Siren Chirps with Arm/Disarm OFF *ON* 19 “Wake Up" pulse on Unlock (1-sec. +12V to IGN) ON *OFF* 19 OPTION PROGRAMMING TABLE 20 PINK Wire function Carjack *Glow Plug* 21 Starter Cranking Time (Option #16 is set to Timed Crank) 0.7

This wire is used for the Optional Separate Driver’s/Passenger Unlock feature. Connects to unlock circuit for passenger door or doors. See DOOR LOCK WIRING for special configuration options. Orange: (-) Negative Starter Disable/Anti-Grind Output This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect each half to an Orang

• In warm weather when your vehicle may start very quickly, “Timed Crank” mode may tend to over-crank the starter. • The only way to possibly correct the above issues is to go to the Option #21 and adjust the cranking time. When in “Timed Crank” mode, the cranking time can only be adjusted manually through option #21. When using Ultra-Smart Tachless or Regular Tach modes, cranking time is adjusted automatically. 18 DIESEL GLOW PLUG DELAY DIESEL GLOW PLUG DELAY This feature provides a solution fo