Assessments - 3, GPA: 4.3 ( )

Fabricante : Monessen Hearth Arquivo Tamanho: 2.89 mb Arquivo Nome : Língua de Ensino:

Hearth Extension A hearth extension is not required with this appliance. If a hearth extension is used, do not block the lower control compartment door. Any hearth extension used is for appearance only and does not have to conform to standard hearth extension installation requirements. Wall finishes / Surrounds / Mantels Note: Combustible wall finish materials and/or surround materials must not be allowed to encroach the area defined by the appliance front face (black sheet metal). Never allow combustible materials to be positioned in front of or overlapping the appliance face (see Figure 5; also see Figure 30 on Page 23). Non-combustible materials, such as surrounds and other appliance trim, may be installed on the appliance face with these exceptions: they must not cover any portion of the removable glass panel. Vertical installation clearances to combustible mantels vary according to the depth of the mantel. See Figure 6. Mantels constructed of noncombustible materials may be installed at any height above the appliance opening; however, do not allow anything to hang below the fireplace hood. Note: We recommend the use of high-temperature paint (rated 175°F or higher) on the underside of the mantel. 5 (127) 8-1/4 (209) 14 (356) 12 (305) 19 (483) Figure 5 - Minimum Distance to Unprotected Side Wall Top View of fireplace 45o Protected wall shown in white Inches (millimeters) Combustible materials may project beyond one side of the fireplace opening as long as they are kept within the shaded areas illustrated here. Combustible Materials Allowed In Shaded Area “Safe zone” Combustible walls shown in dark gray. At 14" minimum side wall clearance, a combustible wall can project to any length. At 8-1/4" side wall clearance, a combustible wall can project 12". 8 (203) 2 (51) 4 (102) 6 (152) 8 (203) 10 (254) 12 (305) 10 (254) 14 (356) 18 (457) 16 (406) 12 (305) Top of Appliance inches (millimeters) Mantel depth Note -Hood shown as positioned. Figure 6 - Minimum Mantel Clearances Header NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. pre-Installation Steps (Remove Glass Enclosure Panel) The appliance is shipped with all gas controls and components installed and pre-wired. Note: Remove the glass enclosure panel before installing the fireplace. To remove the glass enclosure panel: 1. Remove the shipping carton, and then remove the shipping pad, exposing the front glass panel. 2. Open the two latches securing the glass panel (under the firebox floor). 3. Remove the glass panel by tilting it outward at the bottom and lifting it up. 4. Set aside the glass enclosure panel in a safe location to protect it from inadvertent damage. TYPICAL INSTALLATION SEQUENCE The typical sequence of installation is outlined below, with page number references to the related detailed instructions. NOTE: Each installation is unique and may result in variations to these steps. Step 1. (Pages 8–10) Construct the appliance framing. Position the appliance within the framing and secure...

Baixe o seu

Para fazer o download, introduza 2 dígitos :