Pro16 is a trademark of Aviom, Inc. All other trademarks are property of their respective owners. Information in this document is subject to change. All rights reserved. Copyright ©2006 Aviom, Inc. Printed in USA Document Rev. 1.01 ! Warning Failure to observe the following warnings may lead to risk of serious injury from fire or electric shock. Before installing the card, you must refer to the owner’s manual of the host device or to the Yamaha website to verify that your host device supports th

Copyright ©2004 Aviom, Inc. Printed in USA Document Rev. 1.01 Part Number 9301 1006 0001 Aviom, Inc. 1157 Phoenixville Pike Suite 201 West Chester, PA 19380 USA +1 610-738-9005 +1 610-738-9950 (fax) ! READ THIS FIRST Important Safety Instructions 1. Read these instructions. 2. Keep these instructions 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the ma

For systems larger than 32 channels, Aviom offers the AN-16SBR System Bridge as an option. The System Bridge allows up to four A-Net streams to be combined into a single Cat-5e cable for distribution over long distances. A 32-channel system is comprised of two pair of Pro16 Series I/O units, each providing a 16-channel data stream. (Remember that two AV-M8 units cascaded via the ADAT link create a single Pro16 A-Net stream.) Since the Pro16 system is modular, you can connect the Pro16 Series uni

2. 3. 4. 5. 6. MH10 Rear Panel . . . . . . Rear Pan el Comp onents 11 Power On/Off Switch IEC Power Inlet Fuse Holder Backup DC Power Inlet, 4-pin XLR Manual Mode configuration selector button Manual Mode configuration LED A-Net ports, SFP connectors, 2x A-Net ports, EtherCon connectors, 8x 1. 2. 3. 4. 5. 6. 7. 8. MH10f Rear Panel . . . . . . . . Front Panel Features This section describes the features and functions of all front-panel components of the MH10 and MH10f Merger Hubs. Network Mode In

About Your Pro64 Product The locking EtherCon connector is similar to an XLR plug, the kind commonly used on microphone cables. Insert an EtherCon-equipped cable into the jack until it clicks and locks in place. To remove the cable, press on the metal release tab at the top of the panel-mounted EtherCon jack and pull the connector outward. The SFP Module The MH10f Merger Hub ships with two 100 Mbps SFP format fiber optic ports (9 and 10) which allow the user to connect optional single-mode or mu

This means that a separate power supply is not needed to use the product with the power systems found in most countries. You should always use the power supply that shipped with your Aviom product. When travelling, you may need plug adapters to use the power supply with the AC outlet plug shape variations in use throughout the world. Should you need to replace the power supply that came with your product, we recommend using only a power supply that meets the following specifications. Type: Input

This will send the same sixteen audio channels being transmitted by the A-Net input module to the next A-Net device so that another unique monitor mix can be created. An unlimited number of A-Net devices can be connected in series using this method. Any A-Net device, including A-Net Distributors can be connected. DC Power Input Connect the DC power supply to the jack on the rear of the A-16R Personal Mixer. Use only power supplies designed for your Aviom products. When using the optional A-16D o