2 INSTALLATION INSTRUCTIONS................................................................... 3 Unpacking ..........................................................................................................................3 Location Requirements ...............................................................................................4 Electrical Requirements ..............................................................................................4 Undercounter Installation.....

¦ This compactor is intended for household use only. ¦ Use only for intended use as described in this manual. Do not use other than manufacturer's recommended attachments. SAVE THESE INSTRUCTIONS INSTALLATION INSTRUCTIONS Installer: Leave Use and Care Guide with the homeowner. Homeowner: Keep Use and Care Guide for future reference and for local electrical inspector.s use, if required. Unpacking WARNING Excessive Weight Hazard Use two or more people to move and install compactor. Failure to do s

5. Replace drawer. If toe plate still rubs floor covering, repeat steps 1-4. Installing a Custom Panel Dimensions Use these dimension drawings to create a custom panel for use without a trim kit. The panel should be a minimum of ..." (13 mm) thick. Installation 1. Remove the 2 rubber bumpers from the lower corners of the inside drawer front. Set aside the bumpers and discard the screws. 2. Align the bottom of the custom panel with the bottom of the exterior drawer front and rest the panel on the

4. Insert the bottom tabs of the air filter cover and push in until the side tabs snap into place. Cleaning Before cleaning the compactor, turn the Key-Knob (or Key-Switch) to the OFF & LOCK position and remove it. NOTE: Any services other than those outlined in this section should be performed by a designated service representative. Cleaning Exterior Surfaces 1. Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use ab

Your call—and your question—will be answered promptly and courteously. GE Answer Center® service is open 8:00 a.m. to 10:00 p.m. Monday–Friday and 8:00 a.m. to 7:00 p.m. on Saturday. OR Visit our Website at: ge.com (U.S.), ge.com/ca (Canada) A GE consumer service professional will provide expert repair service, scheduled at a time that’s convenient for you. Many GE Consumer Service company-operated locations offer you service today or tomorrow, or at your convenience (7:00 a.m. to 7:00 p.m. week

Attach tip-over bracket to compactor with one slotted head screw on each side. • Remove the compactor drawer for easier handling. • Then position the compactor just in front of the cabinet opening. • PLUG POWER CORD INTO THE WALL RECEPTACLE. • Slide compactor back into cabinet opening. Note: Make certain that the leveling feet caps are on the leveling feet and the power cable is not under compactor. The short leg of anti-tip bracket should be completely under the lip of the countertop but not so

NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Use and Care Book for future reference. This appliance must be properly grounded. See “Power Supply”, page 5. Cet appareil doit etre mis a la terre correctement. Voir la section « Alimentation electrique » en page 5. WARNING AVERTISSEMENT If you have a question concerning the installation of this product, call the GE Answer Center® Consumer Information Service at 800.626.

Dimensions and clearances A – 34" (864 mm) adjustable to 35" (889 mm) B – 12" (305 mm) C – 20-1/4" (514 mm) D – 22" (559 mm) E – 2-3/4" to 4-1/4" (70 mm to 108 mm) base is adjustable from front panel Note: If cord is to be plugged in directly behind compactor add 2-1/2" to overall depth in order to allow proper clearance for the electrical cord. Installation Preparation Built-In Compactors Standard Appearance Panel Options The Monogram compactor models ZCG3300 and ZCG3100 come with a white/black

It may be located in any convenient space under a countertop. DO NOT OPERATE FREE-STANDING because the compactor will tip over when the drawer is pulled out. Additional Specifications: A 115 Volt, 60 Hz. power supply is required. An individual properly grounded branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical outlet location is critical for proper cord

Before installing, consult installation instructions packed with product for current dimensional data. Warranty Information: Full one-year warranty, in-home service, parts and labor.* Full five-year warranty, parts and labor on the compressor, evaporator and all connecting tubing.* *See written warranty for complete details. Note: The addition of a 3/4" thick front panel will result in a front to back depth of 24-1/16". For answers to your Monogram® GE Profile Performance Series,™ GE Prof