© 2007 Printed in the USA. 3358-491 Rev C All Rights Reserved Warranty .............................................................Service 2 ........................................................... 7 Safety ........................................................ 2 Storage .......................................................... 8 Setup .....................................................................Troubleshooting 3 ............................................ 8 Operation ...........

Failure To Do So Can Result in Serious Injury. • Assembly • Maintenance • Operation • Repair Parts Sold by Sears, Roebuck and Co., Chicago, Ill. 60684 USA 534886441-1-03/16/91 © Sears, Roebuck and Co., 1991 ONE YEAR LIMITED WARRANTY ON CRAFTSMAN POWER BLOWER If this ELECTRIC BLOWER fails to perform properly due to a defect in material or workmanship within one (1)year from date ofpurchase, Sears will repair it free of charge. If this ELECTRIC BLOWER is used for commercial or rental purposes, thi

if it still does not fit, contact a qualified electrician to install the proper outlet Do not change the appliance or extension cord plug in any way.. Use only an extension cord recommended for outdoor use. _, WARNING: If you do not fully seat the extension cord on the inlet plug, or if the plug and cord do not fit firmly, the loose plug could lead to overheating and cause a fire, possibly burning you or others. Ensure that you fully seat the cord on the plug. Check the connection regularly to e

If you loan this unit to others, also loan these instructions to them. SPECIAL NOTE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swelling. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of

• Use the full blower nozzle extension so the air stream can work close to the ground. • Clean up after using blowers and other equipment. Dispose of debris appropriately. • Use the trigger lock (Fig. 16) to keep the trigger depressed while operating to make continuous operation easier. APPLICATIONS 1 Use the blower for trees, shrubs, flower beds and hard-toclean areas. 2. Use the unit around buildings and for other normal cleaning procedures. 3. Use the blower around walls, overhangs, fences an

CALiFORNiA EVAPORATIVE EMiSSiON CONTROL WARRANTY STATEMENT Your Warranty Rights and Obligations The California Air Resources Board and Sears Brands LLC (Sears) is pleased to explain the evaporative emission control system's warranty on your 2007 model year and later small off-road (equipment type) engine. In California, new equipment that use small off-engines must be designed, built, and equipped to meet the State's stringent anti-smog standards Sears must warrant the evaporative emission contr

SAE 30 Oil Crankcase Oil Capacity .................................................................................................................................................................. 2.03 oz (60 ml) Fuel ......................................................................................................................................................................................................... Unleaded Carburetor ............................................................

WARNING: Avoid accidental starting. Make sure you are in the starting position when pulling the starter rope (Fig. 11 and 12). To avoid serious injury, the operator and unit must be in a stable position while starting. Do not set unit on any surface except a clean, hard area while starting. Debris such as gravel, sand, dust and grass could be picked up by the air intake and thrown out by the discharge opening. This could damage the unit, property, or cause serious injury to bystanders or the ope

This nozzle should be used when there is a need to blow in a limited or concentrated area. In general uses, such as leaf or grass blowing, the nozzle should not be used. Installing Blower Tube Install the blower tube over the blower outlet and push it on until both tabs snap into place (Fig. 1). ASSEMBLING UNIT AS A VACUUM To assemble the unit as a vacuum, begin by removing the blower tube. Refer to the previous section. Vacuum Tube Assembly NOTE: If the unit was assembled as a blower unit, remo

(Figure 9) 2. Pump primer bulb10 X by pushing up on the bulb(D). (Figure 11) 3. Your unit is designed with a 3 position choke: FULL CHOKE “ ”, PARTIAL CHOKE “ ”, and RUN “ ”. Move choke lever to FULL CHOKE “ ” position. (Figure 10)(DO NOT PRESS THROTTLE LOCK OR TRIGGER.) 4. With unit on the ground, hold top of blower-not engine housing cover as it may be hot-step on bottom of frame with foot. (Figure 12) Fig. 9 ACB Fig. 10 123 D Fig. 11 10 STARTING/STOPPING INSTRUCTIONS NOTE: The unit uses the I