6120 Stoneridge Mall Rd., Suite 210 Pleasanton, CA 94588 USA 800-965-2008 • 925-226-0888 • FAX 925-463-0147 • support@ACCUSPLIT.com 980-312 ACCUSPLIT® EXCLUSIVEAX602RSTOPWATCHOPERATINGINSTRUCTIONS ACCUSPLIT®AX602RDIGITAL 100 MEMORY RACER STOPWATCH WITH SPLIT AND LAP TIME MEASUREMENT FEATURES The Quartz Stopwatch is a digital stopwatch featuring memory and stroke/frequency measuring func- tions. In addition, the stopwatch is water resistant. Therefore, it is suitable for aquatic sports or use in

(Time I Calendar Display)

The three dark gray pads must be facing up (away from the case back). c. Finally, put the gasket on top of the gasket holder, and gently push both into the case back until they pop into place. 8. Turn the electronics module over so that the battery is facing the inside of the case back. Gently push the electronics module down into the gray rubber gasket, until it seats. It will be firmly in position if this is done correctly. 9. Slide the button set out of the front case (you'll see that the

The watch uses a high capacity CR2032 Lithium battery, which has an expected life of more than five years in this watch. To change the battery, you will need a set of large jeweler's screwdrivers (including Phillips head). Note: If this looks too complicated, you can always send your watch back to ACCUSPLIT for battery changing instead. See for details. 1. Turn the watch over and select the correct size Phillips screwdriver (the fastening is very tight, so the screws will strip easily if you

5. S4 – After all the adjustments are completed, press “A” repeatedly until watch exits set mode and returns to the TIME/CALENDAR display. Notes: 1. Hour digits are displayed in the 24-hour indication. 2. Year digits can be set from 1988 to 2027. The calendar adjusts automatically for odd and even months including February of leap years. seconds minutes hour year month date Note: The watch exits set mode automatically after setting date. 8-9 A A B • “Split time” refers to an elapsed time requir

• “Lap time” refers to an elapsed time required to cover a given section of the whole distance. Lap time Split time Start 1. STANDARD MEASUREMENT Hour Seconds Minutes 1/100 seconds START STOP RESET 8 2. ACCUMULATED ELAPSED TIME MEASUREMENT 9 START STOP RESTART RESET STOP Restart and stop of the stopwatch can be repeated by pressing “A”. B A A A 10-11 10 3. SPLIT TIME/LAP TIME MEASUREMENT Note: When the number of stored measurements exceeds 90, fl ashing “FULL” appears, and when it exceeds 100, a

E/IGLE 602M100R MULTI-FUNCTION STOPWATCH STOPWATCH OPERATING INSTROCTIONS This watch has two modes-TIME and STOPWATCH. Press the [MODE] button to cycle continuously through these modes. TIME MODE To set current date and time of day, press [RESET] button. SECONDS indicator will flash to indicate you are in SET mode. Press [RESET] to cycle through and set each field (SECONDS -> MINUTES -> HOURS -> YEAR -> MONTH -> DAY). Field being set will flash. Press [START] button to set each field. STO

vary with shock, temperature, or aging of crystal). Batteries Batteries should last tor 3 years. If display becomes dim, open back and replace with Duracell D357, Eveready D357, or Ray-O-Vac RW42. ACCUSPLIT, Inc. 3090 Independence Drive, Suite 148 Livermore, CA 94551 USA 800-935-1996 • 925-290-1900 • FAX 925-290-1930 support@ACCUSPLITcom

Hold down for Rapid Review. RECHARGING To recharge the stopwatch battery, use SBLCHARGER kit (included with each watch). SBLCHARGER includes provision for charging watch from normal 120 Volt electrical outlet, from cigarette lighter in car, or from USB port on a computer. With continuous use of the backlight, the watch will last at least 10 hours before needing a recharge. If the backlight is never used, a single charge will last approximately six months (up to one year if stopwatch is used