• Install a hubcap onto each wheel by aligning the 5 tabs on the hubcap with the 5 slots in the wheel, and then pushing it into place. Ensure that ALL 5 snaps have engaged securely and the hubcap cannot be pulled off. Figure 4 Installing the Front Wheels • Take one of the double wheel sets and locate the small hole in the rotating bracket that is inside the red lever. • Push the front axle into this hole and keep pushing the wheel set onto this axle until you hear an audible click. See Figure 5.

For a younger child, the shoulder straps should be positioned through the lower sewn-in loops on the seatback. For a young child that is tall, the shoulder straps may be positioned through the upper sewn-in loops on the seatback. For a taller child, use the shoulder straps WITHOUT positioning them through these sewn-in loops. To re-position the shoulder straps, unbuckle them from the harness buckle and feed these straps through the sewn-in loops, insuring that they are not twisted. Re-buckle the

Keep these instructions for future reference. • Failure to follow these instructions could result in serious injury or death. • Never leave child unattended. • Avoid serious injury from falling or sliding out. • Always use safety belts and ensure that all children are positioned according to these instructions. • Keep all small parts out of the reach of children while assembling the stroller. • Be certain that the stroller is fully opened, the safety latch is in position, and the wheel brakes ar

Ensure that they snap into place. See Figure 24. • Adjust the seat belt to be snug around the child’s waist. • Be sure that the BOTH of the child’s feet are fully on the platform at all times. • Be sure that BOTH of the child’s hands are holding the handles on the frame. Figure 23 Figure 24 ! WARNING NEVER allow a rear seated child to use the canopy as a hand hold. Caboose Ultralight Instruction Manual Page 10 Using the Stroller as an InfantCar Seat Carrier • To use the stroller to carry an infa