The hour value will blink. (D Press the Adjust button to set the correct hour. Set the minute. * © Press the Set button. The minute value will blink. (2) Press the Adjust button repeatedly to set the correct minute. Press the Set button at the exact time the minute changes to finalize the date/time setting. Press the On/Off Start button to switch off the power. 6 7 When the date or time are blinking, the clock is stopped. During leap years, 3/1 will be displayed on February 29.

Keeping an accurate record of your blood pressure will help your doctor diagnose and possibly prevent any health problems in the future. Basic of Blood Pressure Your heart acts like a pump, sending blood surging through your blood vessels each time it contracts. Blood pressure is the pressure exerted by blood pumped from the heart on the walls of blood vessels. Systolic pressure is the pressure exerted when the heart contracts and pumps blood into the arteries. Diastolic pressure is the pressu

(For storing measurement values, see p. 17.) • The pulse rate value is the beats per minute calculated based on the pulse rate during measurement. 3. To switch off the blood pressure monitor, press the On/Off Start button. • If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 5 minutes. SY^Dl* mmHg DIASTOLIC mmHg_ mss V 15 Flash warning system for hypertensive readings If the measured values fall within the hypertension range, the

EW3006 Modelo No. EW3006 Before operating this device, please read these instructions completely and save this manual for future use. Antes de usar este dispositivo, lea completamente estas instrucciones y guarde este manual para utilizarlo como referencia en el futuro. Panasonic Oscillometric Diagnostec™ Wrist Blood Pressure Monitor Model EW3006 Is a device Intended to measure systolic and diastolic blood pressure and pulse rate of an adult Individual by using a pressurized cuff on the left

ENERGY SAVING FEATURE If the watch receives no transmitter signal after 5 minutes, the SE200 will switch back to the previous display mode. SPECIFICATIONS Real time clock: 12/24 hour with hour / minute / second Stopwatch: 00:00:00 to 29:59:59 (hrs: min: sec) Heart rate: 30 - 240 bpm Upper limit: 80 - 240 bpm Lower limit: 30 - 220 bpm Power: Watch 1 x CR2032 3V battery Chest belt 1 x CR2032 3V battery Operating temp: -10°C to +50°C (14°F to 122°F) Storage temp: -20°C to +60°C (-4°F to 140°F) Wate

• You unconsciously bent your elbow. • The upper arm became very tense. • You moved your arm. • Etc. Return to the proper posture. o Lit Beep beep (short buzzer sounds) A movement which will cause large differences in measurement values occurred. • Body movement was large. • Body movement occurred several times. • Arm movement was large. Remeasure (Remeasure mark E is shown.) • It will also be lit in the following cases: • Pressure cuff tape fastener became unfastened. • Tube came out. • Etc. (