1. NE JAMAIS utiliser d’essence, benzene, de peinture, diluant ou autre compose chimique pour nettoyer cet appareil; toutes ces substances feront subir des dommages ou deformations aux composants de plastique et degraderont la finition. 2. Ne jamais verser de l’eau directement sur l’appareil; ceci pourrait faire subir des dommages aux composants electriques et a l’isolant des conducteurs electriques. 3. Utiliser uniquement de l’eau tiede, un detergent pour lavevaisselle et un chiffon doux pour e

ATTENTION : Lire attentivement les consignes de securite et les instructions d'utilisation avant l'utilisation initiale de ce produit. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the Dehumidifier changes ownership, be sure this manual accompanies the unit. CONSERVER CES INSTRUCTIONS POUR CONSULTATION ULTERIEURE En cas de revente du deshumidificateur, ce manuel doit etre inclus avec l'appareil. Printed in China (P.R.C.) PORTABLE DEHUMIDIFIER Table of contents . . . . . . . . . . . . . . . .

When the wine cooler is not to be used for a long period of time, disconnect the plug and leave the door partially open. NOTE: Wait 3 to 5 minutes before restarting if operation has been interrupted. Interior Light The operation of the interior light is "manually" controlled and does not operate with the opening or closing of the door. To operate the light; manually press the “light” key pad located on the electronic control panel NOTE: Leaving the interior light on for extended time periods, wi

A mild detergent (diswashing liquid) is recommended. 4) Rinse the filter well using clean water. Allow time to dry before reinstalling into the unit. 5) Replace the air filter and cover. 6) Replacement air filter information is available by contacting the Customer Service Department at: l-800-26-I>anby' (1-800-263-2629). <> TROUBLESHOOTING Occasionally, a problem may occur that is minor, and a service call may not be necessary. Use this troubleshooting guide for a possible solution. If the

A failed unit can cause extreme overheating or death in such an enclosed, unattended space. POWER SUPPLY CORD The power cord supplied with this air conditioner contains a device that senses damage to the power cord. To test if your power cord is working properly, you must do the following: 1) Connect the power supply cord to an electrical outlet. 2) The power supply cord has two buttons located on the head of the plug. One button is marked “TEST”, and the other is marked “RESET”. Press the ‘

♦ The air conditioner starts up in the Cool mode. You can change modes at any time. To adjust the temperature, press the /'''■»Nor buttons on the remote control or unit one or more times until the desired temperature is displayed. The temperature can be set between 18°C and 30°C. Result: ♦ Each time you press the | a |or | v | buttons: - The temperature is adjusted by 1°C and displayed on the control panel - The unit beeps ♦ The air conditioner starts cooling, if the room temperature is h