Except for the differences noted in this insert, all other content in the Model SB1039 Owner’s Manual applies to this machine. Before operating your new lathe, you MUST read and understand this insert, the entire Model SB1039 Owner’s Manual, and the Fagor DRO Owner’s Manual to reduce the risk of injury when using this machine. Keep this insert for later reference. If you have any further questions about this manual insert or the differences between the Model SB1039F and the Model SB1039, contact

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. #8232CR Printed in China ...................................................................................................................................................................................................................................................................................................................................................

Live center installed. Figure 24. Faceplate and dead center installed. NOTICE Failure to keep dead center point well lubricated will gall the dead center and workpiece. -26- M1049 Benchtop Lathe (Mfg. Since 8/09) SHOP FOX, Using the Steady Rest The steady rest serves as a support for long shafts. The steady rest can be placed anywhere along the length of the ways. To use the steady rest, do these steps: 1. Carefully place the steady rest on the lathe bedways. 2. Loosen the finger lo

Besides the data sheet and parts in this insert, the content in the Model W1754 owner's manual is the same for both machines. Before operating your new machine, you MUST read and understand this insert and the entire Model W1754 manual to reduce the risk of injury from improper use or setup. If you have any further questions about this manual insert or the differences between the Model W1754S and the Model W1754, contact our Technical Support at (360) 734-3482 or email tech-support@shopfox.biz.

Close attention to detail, ruggedly built parts and a rigid quality control program assure safe and reliable operation. Woodstock International, Inc. is committed to customer satisfaction. Our intent with this manual is to include the basic information for safety, setup, operation, maintenance, and service of this product. We stand behind our machines! In the event that questions arise about your machine, please contact Woodstock International Technical Support at (360) 734-3482 or send e-mail t

The operator or bystanders may be struck by flying stock, or the operator’s hands can be pulled into the blade during the kickback. Figure 42. Typical 45° rip cut. Figure 41. Blade tilted to 45° (guard removed for photo clarity). Rip Cuts Rip cuts or "Ripping" means cutting with the grain of the workpiece. In other materials such as MDF or plywood, ripping simply means cutting lengthwise. To make a rip cut, do these steps: 1. Review Preventing Kickback on Page 11 and take the necessary precautio

Main line size labeled on sketch. ............................................................................ Figure 50. Branch line sizes labeled on sketch. Total CFM Branch Line Size 600 5" 700 5" 800 6" 1000 6" 1200 7" 1400 8" 1600 8" Figure 51. Branch line sizing chart by total CFM (for use when multiple machines share line). OPERATIONS -33 W1808/W1809/W1810 Cyclone Dust Collectors OPERATIONS Calculating Duct Resistance Adding duct work, elbows, branches and any other components to a duct l

........... ....................................................................................................................................................................................................................................................... ........... ....................................................................................................................................................................................................................................

........................... ....................................................................................................................................................................................................................................................... ....... ..................................................................................................................................................................................................................... ..

Contents INTRODUCTION..................................................................................................3 INTRODUCTION SET UPELECTRICAL SAFETYWoodstock Technical Support............................................................................ 3 Specifications............................................................................................... 4 Controls and Features..................................................................................... SAFETY............