Roll lengths are +/- 5% and widths are -0/+1/2". 2. Maximum roll widths are: SA600-G10 90.55" SAR-1 90.55" All other polyester medias 110" Fiberglass media 84" 3. Roll Lengths are: SA600-G10 792" SAR-1 100 ft. FP3 50 ft. 1GT 90 ft. PS125 90 ft. All other polyester media 100ft. Fiberglass media 300 ft. 4. Any width can be custom cut from 6" to maximum width for any media product. 5. Rolls are bagged in minimum 3-mil clear plastic bags. 6. Rolls are identified with a tag on top of each bag. 7. Rol
2. The width of a link panel shall be 3/4" under nominal size from wire to wire. 3. The total length of a link panel shall measure the nominal size from wire to wire when fully extended. 4. A 1.5" gap from wire to wire exists between all link panels 5. All custom panels sizes are considered nominal and support frames are 3/4" under listed size unless EXACT is specificed. 6. Wire support frames for custom link panels will be produced using the least amount of frames to produce the desired length
The KKM offers large filtering area, high dust holding capacity, uniform loading and low resistance to air flow. The KKM filter has a rugged galvanized steel frame that encloses the bonded expanded aluminum mesh media. The corners are mitered and the frame is secured with pop rivet(s). The KKM has drain holes in three corners. The bonded aluminum media is slit and expanded to several different size openings. This design allows contaminants to be trapped throughout the entire filter depth and n
Reference 63 Fed. Reg. 59 (March 27, 1998) and 40 C.F.R. 9, 63. The EPA Test Method 319 is a testing protocol in which potassium chloride and oleic acid are substituted for chromate paint. These chemical substances attempt to simulate dry and wet overspray characteristics of the chromate paint. This testing protocol verifies that an air filtration system has met minimum efficiency requirements, under laboratory conditions, utilizing potassium chloride and oleic acid. If a spraybooth existed befo
This polyester media is treated on the inside with a special tackifier to help hold the paint particles to the mediia as they Paint in grams Pressure Drop “w.g. Pressure Drop “w.g. 0.4 0.3 0.2 0.1 enter the filter. The second media layer is a tightly needled 0.0 0 50 100 150 200 250 300 1/4” 6 denier polyester media. This layer prevents the fine Air Velocity (FPM) particles from exiting the filter. Pressure Drop 0.5 Cube filters have a distinct advantage over flat pads (more surface area). An in
The fibers are formed into progressively denser layers. Fiberglass media is ideal for capturing paint overspray due to its ability to maintain an open outer layer. It is this initial outer layer that allows the entire depth of the media to hold paint particulate and not “surface load” like many overspray collectors. The media is solid yellow and has a skin backing on the downstream side. This skin backing helps prevent the media from sagging when particulate is captured and provides a final bar