Assessments - 1, GPA: 3 ( )

Fabricante : Napoleon Fireplaces Arquivo Tamanho: 2.16 mb Arquivo Nome : Língua de Ensino:

Adjust the flame height as desired after lighting the appliance by rotating the variable adjustment control knob (HI/LO) located on the front of the valve (refer to Figures 3 and 4). SUPERIORSUPERIORDIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS MAINTENANCE (See Maintenance Schedule, Page 26) Refertothemaintenancescheduleformaintenance tasks, procedures, periodicity and by whom they shouldbeperformed. Alwaysverifyproperoperation of the appliance after servicing. WARNING Turn off gas and electrical power to the fireplace and allow it to coolbefore cleaning or servicing the appliance. CAUTION: Wear gloves and safety glasses for protection while doing required maintenance. Verify proper operation after servicing. S'assurer que l'appareil fonctionne adequatement une fois l'entretien termine. Always turn off gas to the pilot (millivolt appliances) before cleaning. Before relighting, refer to the lighting instructions inthismanual.Instructionsarealsofound on a pull-out panel located in the control compartment. Before re-lighting the fireplace, refer to the lighting instructions in this manual. Instructions are also found on pull-out panels located below the glass door in the control compartment. Inspect Venting System The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service technician (inspection should include ensuring that exhaust or intake passages are unobstructed and vent components are properly assembled and not damaged). Homeowner must contact a qualified service technician at once if any abnormal condition is observed. If the venting system is disassembled for any reason, a qualified service technician should follow vent installation instructions for proper reassembly and proper sealing of the venting system components. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Cleaning Glass (Also see Front Glass Enclosure Panel, Removal and Installation on Page 11). Note: Clean glass after first two weeks of operation (after Burn-In period is over) and then only when necessary and only when the fireplace is cool. Wipe surface with clean, dampened, soft cloth. Follow with dry, soft towel as desired. Take care not to scratch the glass surface. Clean the viewing glass periodically to remove any build-up caused from the following: IMPORTANT: Do not use abrasive cleaners on glass. Never clean the glass when it is hot. • During start-up, it is normal for condensation to form on the inside of the glass (this condensation and fog will usually disappear in a few minutes). The moisture can cause lint, dust and other airborne particles to cling to the glass surface. • Initial curing of the high temperature paint and burning off of lubricants used in the manufacturing process may result in a film on the glass. • A white coating may form on the glass as a result of impurities and minerals in the fuel. It is r...

Baixe o seu

Para fazer o download, introduza 2 dígitos :