Assessments - 3, GPA: 4.3 ( )

Fabricante : Regency Arquivo Tamanho: 2.16 mb Arquivo Nome : Língua de Ensino:

All air for combustion is brought in from the outside and exhaust gases are vented through the same direct-vent, co-axial (intake/exhaust) vent system. The Millivolt appliances have a millivolt gas control valve with piezo ignition system. If any optional accessories which require electrical power are being installed, the electrical power must be provided at the time of appliance installation. The Electronic appliances have a battery backed-up electronic intermittent pilot system. No external electrical power is required to operate these appliances. These appliances comply with National Safety Standards and are tested and listed by ETL/ Intertek (Report No. 100353019PRT-001) to ANSI ZZ21.88 (in Canada, CSA-2.33), and CAN/CGA-2.17-M91 in both USA and Canada, as vented gas fireplace heaters. The Installation must conform to local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54-latest edition, or the Natural Gas and Propane Installation Code, CAN/CSA B149.1-latest edition. The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, the latest edition of the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1 - latest editions. Burn-in Period During the first few fires in this appliance, there will be some odor due to the curing of the paint and burning off of lubricants used in the manufacturing process. Depending on your use, the burn-in period may take a few hours or a few days. KEEP YOUR HOUSE WELL VENTILATED DURING THE BURN-IN PROCESS. THE ODOR AND HAZE EMITTED DURING THE BURN-IN PROCESS CAN BE QUITE NOTICEABLE AND MAY SET OFF A SMOKE DETECTOR. If an optional blower is installed, do NOT turn it on during the burn-in period. IMPORTANT NOTE! A white film may develop on the glass enclosure panel during the first few fires as part of the burn-in process. The first few times you use the fireplace, clean the glass after each use (AFTER THE GLASS HAS COMPLETELY COOLED); otherwise, the white film will bake onto the glass and become difficult to remove. See “Cleaning Glass” on Page 10. Burner Orifice Sizes Elevation 0-4500 feet ( 0-1372 meters) Model Series Nat.Gas drill size (inches) Propane drill size (inches) SLDVT-30 #50 (0.070")* H4873• #61 (0.039")* 35M91• SLDVT-35 (0.0748")* H1355• (0.045")* 75L10• SLDVT-40 #44 (0.086")* 60J80• (0.048")* 99K78• SLDVT-45 (0.090")* 37L70• #54 (0.055")* 99K79• *Standard size installed at factory. Table 4 •Part /Cat. Number. SUPERIOR® DIRECT-VENTGASFIREPLACES•MODELSSLDVT-30/35/40/45•CAREANDOPERATIONINSTRUCTIONSOrifice Sizes (Sea Level to High Altitude – All Models) These appliances are tested and approved for installationsatelevationsof0-4500 feet (0-1372 meters) above sea level using the standard burner orifice sizes (marked with an asterisk (*) in Table 4). For higher elevations, contact your gas supplier or qualified service technician. Installtheapplianceaccordingtotheregu...

Baixe o seu

Para fazer o download, introduza 2 dígitos :