Assessments - 4, GPA: 3.8 ( )

Fabricante : Superior Arquivo Tamanho: 2.16 mb Arquivo Nome : Língua de Ensino:

The standard controls for appliance operation are located behind the panel below the appliance front glass enclosure panel (Figure 1). Optional control switches are also available (see Page 19 - Remote Wall Switch, Remote Control, Unit Mounted Rocker Switch or Wall Thermostat). Operation of millivolt and electronic gas control systems are different. Before lighting and operating your appliance determine if you have a millivolt or electronic appliance. Familiarize yourself with the gas control valve that your appliance uses. Refer to Figure 1 for access to the gas control valve. Millivolt Appliances - Appliances with Millivolt systems will be fitted with the gas control valve shown in Figure 3. Electronic Appliances - Appliances with electronic systems will be fitted with the electronic valve shown in Figure 4. Millivolt Appliances - To light millivolt appliances refer to Figure 1. Detailed lighting instructions are found on Pages 22 and 23. Millivolt appliance lighting instructions may also be found on the pull out lighting instruction labels attached to the gas control valve. Once the pilot is lit, the main burner may be turned ON and OFF using wall switch, remote control, optional on unit rocker switch (FRS), or wall thermostat. To operate: Toggle the switch between its ON and OFF positions. If your millivolt appliance is equipped with an optional remote switch kit (wall switch, remote control, rocker switch, or wall thermostat) and the pilot is lit, the appliance main burner may be turned on and off using the optional switch. Note: To prevent excessive resistance in burner circuit (which can cause burner operation problems), only one burner control switch should be wired to valve. Figure 2 Control Compartment Door Tab Gas Flex Line Gas Shut-Off Valve Valve Piezo Spring Door Latch Lower Control Compartment SUPERIOR SUPERIORDIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS Electronic Appliances Tolightelectronicappliancesrefertothedetailed lighting instructions found on Pages 24 and 25 of these instructions. Electronic appliance lighting instructions may also be found on the pull out lighting instruction labels attached to the gas control valve. If your electronic appliance is equipped with an optional remote wall switch or remote control kit the appliance main burner may be turned on and off with the wall switch or remote control. If your electronic appliance is not equipped with a wall switch or remote control, the main burner must be turned off and on with a gas control switch located in some other location by the installer. Contact the installer for directions. Check batteries, if installed, routinely (ever three months). TO LIGHT THE APPLIANCE DURING A POWER OUTAGE: • Install batteries in battery pack. • Turn unit mounted switch or wall switch to the ON Position. • Unit should spark at pilot and light. • Operate Normally. • Replace batteries if needed. •Afterpowerisrestored,removebatteries. Note: It is ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :