Assessments - 1, GPA: 3 ( )

Fabricante : Stovax Arquivo Tamanho: 2.16 mb Arquivo Nome : Língua de Ensino:

AVERTISSEMENT Ne pas utiliser l'appareil si le panneau frontal en verre n'est pas en place, est craque ou brise. Only doors certified with the appliance shall be used. Seules des portes certifiees pour cet appareil doivent etre utilisees. CAUTION: DO NOT abuse glass door by striking or slamming shut. These are direct-vent appliances. They are designed to operate only when the front glass enclosure panels are installed. Generally the front glass enclosure panel should not be removed except to gain access to the components within the firebox. Removing Glass Enclosure Panels (see Figure 6) 1. To access the glass door securing latches, first open the lower control compartment door (Figure 6) by lifting and pulling the bottom panel forward. 2. Pull the latches forward and down to release them from the door channel. 3. Pull the bottom of the door out a few inches and grasp it on the right and left. Gently lift to release the door from its channel above the door. Pull the door forward. 4. Retrieve the glass door. Visually inspect the gasket on the backside of the frame. Gasket surface must be clean, free of irregularities and seated firmly. 5. Position the door in front of the firebox opening with the bottom of the door held away from the fireplace (Figure 6). Hook the top flange of the door frame over the top of the firebox frame. 6. Let the bottom of the door frame swing gently in towards the fireplace ensuring that the gasket seats evenly as the door frame draws shut. Fasten the two latches located underneath the firebox floor to the door's vee-flange. Close both the latches securely. 7. If desired, install the optional hood. Note the location of the three clips inside the top air channel above the door. The clips are equally spaced on the top surface of the air channel opening. Use a screwdriver to open the clips slightly if needed. Engage the back edge of the eyebrow into the clips to secure. INSTALL VOLCANIC STONE, GLOWING EMBERS AND LOGS NOTE: Turn off all electricity to the appliance before you install volcanic stone, embers and logs. 1. Remove the front glass enclosure panel (see Removing Glass Enclosure Panels on Page 11). 2. Always handle logs carefully to prevent breakage. 3. Install decorative volcanic stone - Sprinkle the decorative volcanic stone in a pleasing pattern (see Figure 7 on page 12). The volcanic stone should be placed directly on top of the firebox bottom, along the slope and to the back at the right and left sides of the burner. Position any ceramic fiber liners before placing the stone. Logs can be positioned after the volcanic stone. 12 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. SUPERIOR® DIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS Figure 7 4. Placement of Glowing Embers - Separate the Embers (rockwool) into pieces about the size of a quarter (see Figure 8). Keep the pieces fluffed up, not matted. Distribute these pieces over the surface of the burner, as shown in Figures 9,...

Baixe o seu

Para fazer o download, introduza 2 dígitos :