IMPORTANT SAFETY INSTRUCTIONS WARNING ! ! To avoid injury when using your Honda Edger, follow basic precautions, including the following: 1. READ THESE IMPORTANT SAFETY INSTRUCTIONS, THE OPERATING INSTRUCTIONS, ASSEMBLY INSTRUCTIONS, USER MAINTENANCE INSTRUCTIONS, AND THE HONDA OPERATING AND MAINTENANCE INSTRUCTIONS CAREFULLY AND COMPLETELY. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly. SAVE MANUALS AND

(64 cm) de longitud Modelo 2300 Manche 60" (152 cm) Lames 20" (51 cm) Modele 2310 Barra de 60 pulg. (152 cm) Cuchillas de 20 pulg. (51 cm) de longitud Modelo 2310 EXTENDED REACH HEDGE TRIMMERHEDGE TRIMMER T TTAILLE-HAIES AILLE-HAIESAILLE-HAIES A LONG MANCHE PODADORA DE SETOS PODADORA DE SETOSPODADORA DE SETOS DE LARGO ALCANCE © 2003 Little Wonder, Div. of Schiller Pfeiffer Inc. All Rights Reserved. Table of Contents Important Information A. Introduction . . . . . . . . . . . . . . . . . . . . .

Use an approved tester. Sparks can ignite fumes. Don’t crank engine with spark plug removed. If the engine is flooded, open the choke and pull recoil until engine starts. If this fails, read and follow the section “Operation” (Pg. 8). Don’t run engine when the odor of gasoline is present or other explosive conditions exist. Don’t operate the unit if gasoline is spilled. Clean up spill completely before starting engine. Don’t refuel indoors or in an improperly ventilated area. Don’t operate your

For safety, read all safety and operating instructions prior to operating machine. TABLE OF CONTENTS Section 1: General Information Serial Number Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Table for BedShaper®Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Section 2: Specifications Engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

C. Stopping the Engine 1. Move the throttle control lever to the “turtle” (slow) position. 2. Turn the key to the “off” position. D. Debris Blockage 1. If a decrease in suction is experienced, there may be a debris blockage in the hose. To remove this blockage, simply grab the handles of the Intake Nozzle and stretch the hose out into a straight line with respect to the Inlet of the unit while the engine is at full throttle. 2. In the event the suction of the hose remains decreased after complet

**Synthetic oils will provide better starting in extreme cold (below -10.F). 10 a. Gasoline/Alcohol blends: Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline by volume) is approved as a fuel for Kohler engines. Other gasoline/alcohol blends are not approved. b. Gasoline/Ether blends: Methyl Tertiary Butyl Ether (MTBE) and unleaded gasoline blends (up to a maximum of 15% MTBE by volume) are approved as a fuel for Kohler engines. Other gasoline/ether blends are not approved. 2. Fuel Warnings

SAFETY SAFETY DECALS An important part of the safety system incorporated in this blower are the warnings and informational decals found on various parts of the blower. These decals must be replaced if they become illegible due to abrasion, etc. It is your responsibility to replace the decals when they become hard to read. The location of these decals and their part numbers for ordering are shown below. IMPROPER USE OR CARE OF THIS BLOWER, OR FAILURE TO WEAR PROPER PROTECTION CAN RESULT IN SERIOU

1. Line trimmer attachment assembly 2. Plastic guard with knife 3. Spool holder 4. Spool with flexible string If you have questions about any topic in this manual,contact your local authorised Mantis dealer. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Special safety information . . . . . . . . . . . . . . . .1 Safety labels . . . . . . . . . . . . . . . . . . . . . . . . . . .2 General safety rules . . . . . . . . . . . . . . . . . . . . .3 MODEL SHAFT TOTAL LENGTH WEIG

Blade Speed Warranty Engine C O M 2 Professionals Demand Little W 2119 19 . 11.7 5 YEAR Push Bulb Priming Anti-Vibration Shock Mounts 10% lighter, 20% faster - The redesigned, reengineered Double Edge Gas Hedge Trimmers are faster and lighter than previous models. This translates to better performance, lowered user fatigue, and higher profits! Lower profile design - The overall lowering of the engine profile allows the user to use the unit comfortably in many different positions. Superior blade

5,826,667. Other US patents pending. Design registrations Granted in USA, Australia, Japan, Great Britain Patent Pending on Cross-Blade System. IMPROPER USE CAN CAUSE SERIOUS INJURY MAKE SURE THIS MANUAL IS READ AND CAREFULLY UNDERSTOOD BEFORE STARTING OR OPERATING THIS EQUIPMENT IMPORTANT MANUAL – DO NOT THROW AWAY Manual always to be available for reference or instructing new operators SUPERVISORS, THIS IS YOUR RESPONSIBILITY ©2003, LITTLE WONDER, Div. Schiller-Pfeiffer, Inc. CONTENTS This pro