Using the cap removal tool provided in the kit, pry the blue cap off the cartridge body. See Fig. 1. 4. Remove the scabbard from the refill dispenser of the color you wish to refill. Insert the filler tube into the corresponding color compartment through either of the two fill holes. Determine appropriate color chamber by following figure 2. Push the filler tube into the absorbent material as far as it will go. Then draw it back out about 1/4" (6.5mm). See Fig. 2 5. Tilt the bottle until the

(fig.2) 2. Remove the top from the black ink bottle and using the syringe remove 5ml of the colour ink (fig.3) 3. The lid has to be removed from the cartridge. Cut around the edge with a sharp knife and then remove (fig.4) 4. Insert the steel filling tube into the appropriate filling holes. (fig.5). Push down into centre of the sponge. IMPORTANT: Cartridge contains a sponge and a slight resistant may be felt. 5. SLOWLY Inject ink. Stop filling before ink overflows as you do not want the ink

MANUFACTURING CORPORATIONESTABLISHED 1931Inkjet Products Limited Warrantyfor U.S.A. and CanadaRepeat-O-Type Manufacturing Corporation warrants its refill ink products against defects in materials andworkmanship for one year from date of purchase. In the unlikely event that a Repeat-O-Type refill ink product does not performsatisfactorily when used as directed, Repeat-O-Type will replace it at no charge. If a cartridge is refilled and will not produceacceptable prints, the ink cartridge may be wo

Place the included blunt needle by screwing it down the tank's opening. Hold the base of the syringe with thumb and forefinger and twist the injecting devise onto it, counter clockwise. First remove the label from the upper side of the cartridge und bore refilling holes. To do so, use the supplied tool to enlarge the 3 existing openings. r m ■ V, w Now insert the syringe inclined into each opening. Slowly and carefully squeeze the ink into each ink chamber, until just under the opening

31 | No. 33 | No. 35 | No. 43 Please carefully read these instructions, before starting refilling a cartridge. In order to avoid any soiling, always place a protective mat underneath the cartridge before starting the refilling process, and keep a dampened cloth at hand, to remove any contamination straight away. These instructions apply to the cartridges mentioned above only. The syringe and injection tools as well as the ink must be kept away from children. We shall not be held liable for dama

31 | No. 33 | No. 35 | No. 43 Please carefully read these instructions, before starting refilling a cartridge. In order to avoid any soiling, always place a protective mat underneath the cartridge before starting the refilling process, and keep a dampened cloth at hand, to remove any contamination straight away. These instructions apply to the cartridges mentioned above only. The syringe and injection tools as well as the ink must be kept away from children. We shall not be held liable for dama

By doing so, ink will flow out of the nozzles and has to be dabbed away immediately with a tissue. This trick allows pressing sealed air bubbles out of the nozzle chamber. Should the cartridge print in streaks, please start a cleaning cycle with your printer software. If the problem remains, dab the nozzles with a dampened cloth or leave them to settle in warm water for few minutes. You are facing difficulties refilling your ink cartridges or require more information about the refilling proced

4 Select the content........................................................................................... 5 Set the duplex option...................................................................................... 6 Set Collation/Finishing features...................................................................... 6 Save paper when you print............................................................................. 6 Select your copy media.......................................