If the mineral content deviates from prescribed pH level (7.2-7.8) deposits on the spa walls, filter, electric heating element or gas heater manifold and piping may adversely affect the condition of your spa equipment. Since the water capacity of your spa is far less than that of a swimming pool, the chemical reaction caused by the presence of one or more persons in the spa is more rapid and pronounced. In other words, it is much more difficult to maintain the proper pH balance in a spa than in

It should be labeled and easily accessible to users. DO NOT USE EXTENSION OR PLUGTYPE CORDS OF ANY KIND. The use of a shut-off box near the spa is recommended. Metal surfaces within 5 feet of the spa must be grounded to the spa. A 120 Volt - 15 Amp GFI rated plug is furnished with the Antigua Silver Spa. CAUTION: This spa will not work if more than one GFCI is used on the circuit. On 220 Volt applications, power supply must be hard wired into the power pack. 120V Antigua Silver Edition Electrica

This secondary circuit will automatically shut off in 30 min if left on. No display at topside* • Check that connection to main board is clean and sound at J8. • Test a new topside control • Check for 120V primary power going into the transformer and for 12V secondary power out of the transformer to J6 and J7 on the board before replacing the transformer. • Relace board if there is 12V to J6 and J7. Display flashes “th1/38” on system start up* • Check that temperature sensing probe connection to

On 220 Volt applications, power supply must be hard wired into the power pack. 110/220 Volt Antigua Electrical Connections: TERMINAL BLOCK Live (black) Hot Black Two Wire & Ground Neutral (white) Neutral Hot Red Ground (copper or green)GRD Note: Your Cyprus Spa’s Heater can be converted to 220 Volts. The Spa’s pump will remain 120 Volts. This change must be performed by a certified electrician. 220 Volt Antigua Electrical Connections: To convert spa from 120 volt to 220 Volt remove white jumper

If the opposite direction is desired, release the button and let the display revert to the current water temperature. Press the button to display the set temperature, and again to make the temperature change in the desired direction. after 3 seconds, the LCD will stop flashing and display the current temperature. Light There are several color options in our spas and by pressing the light button in quick succession the customer can cycle through the different lighting options. BEFORE START UP! IM

This spa must be on adedicated circuit. CAUTION: OWNER’S MANUAL ™ More than one GFCIused on the electricalcircuit will render thisspa inoperable. This spa must be on adedicated circuit. P.O. Box 108 Northumberland, PA 17857 1-800-STRONG-9 1-800-787-6649 1/9/07 Table of Contents Introduction ................................................................................................................................. 1 Safety Instructions.........................................................

OWNER’S MANUAL Liberty ™ 3204 Point Township Drive (Rte 11) • P.O. Box 108 Northumberland, PA 17857 1-800-STRONG-9 1-800-787-6649 12/20/06 Table of Contents Introduction ................................................................................................................................. 1 Health Safety.............................................................................................................................. 2 Installation -Spa placement ............................

Solution: If the problem persists, contact your dealer or service organization. 8 Troubleshooting continued from previous page Problem: A significant difference between temperature sensors has been detected. This could indicate a flow problem. Solution: Check water level in spa. Refill if necessary. If water level is okay, make sure the pumps have been primed. If problem persists, contact your dealer or service organization. Problem: Persistent low flow problems. (Displays on the fifth occurrenc

(repair or replacement) Spa Surface: 3 years Strong Spas warrants the original retail purchaser the surface integrity of the spa against blistering or delaminating as a result of defects in material or workmanship for a period of 3 years. (repair or replacement) Plumbing: 3 years Strong Spas warrants the original retail purchaser the integrity of the spas plumbing against leaks as a result of defects in material or workmanship for a period of 3 years. (parts and labor)3 Equipment: 2 years Strong

A location should be selected to compliment your lifestyle, the view from your house and the ability to supervise the spa. Position the spa in relation to the surroundings of trees, sunlight exposure, wind, bathroom location, landscaping and evening lighting. The spa with water is very heavy, if the spa is placed on flooring or decking, be sure the structure is strong enough to support the weight. The necessary support should be at least 75 pounds per square foot. Install your spa, in a way that