.........................................1 .................6292563-MFC.........Motor Fan Cover (not shown) ...................... .........................................1 .................6292563-CS............ Centrifugal Switch (not shown) .................... .........................................1 .................6292563-SC............Starting Capacitor (not shown) ....................400MFD, 250VAC.............1 .................6292563-RC............Running Capacitor (not shown) ...

Even the fins on the blower fan were subjected to considerable research and development to be sure they made the most effective fan for this application. The result is an air filtration system specifically designed from the ground up to function effectively in the woodshop environment. Legitimate Efficiency A considerable amount of engineering was expended in the design of the PM1200 AFS filtration elements to ensure maximum efficiency. It is important to understand the filtration numbers so oft

Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the planer is installed and running properly. Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions. NOTE: To remove the box from atop the planer table, loosen the table lock handle,

Loaded with features and built for performance and value. The Gold Standard Since 1921. PM15 Planer/Molder The new PM15 from Powermatic FEATURE BENEFIT is loaded with features that make it a standout. Large 5HP motor gives the unit 15" wide planing capacity and enough power to run double knife sets for molding. The stand is fully enclosed and is equipped with integral casters for shop mobility. Two feed speeds, 10 and 20 fpm’s allow you to run quickly for maximum stock removal yet slower speed

High speed can build friction while sanding and cause heat check in some woods. 2. Begin with fine sandpaper (120 grit) and progress through each grit, using only light pressure. Coarser sandpaper tends to leave deep scratches that are hard to eliminate. Use power-sanding techniques to avoid concentric sanding marks around your finished piece. Avoid rounding over the rim and foot with sandpaper; try to keep details crisp. Finish sanding with 220 grit. 3. Remove sanding dust with tack rags or com

TABLE OF CONTENTS Safety Rules ...............................................................................................................................................4-5 Safety: Decals ...............................................................................................................................................6 Specifications ................................................................................................................................................7 R

Creating flat, straight surfaces is crucial in the quest to build elegant projects. Virtually all forms of joinery and the tools that cut them depend on straight edges and square cuts. The POWERMATIC 54A/54HH 6” Jointer makes it easy to achieve the high levels of accuracy you need in this always-crucial operation. Base Cabinet The 21”-wide by 13”-deep all steel base cabinet provides stable footing for the POWERMATIC 54A/54HH 6” Jointer and puts the table surface at a comfortable 32” above the fl

16. Check damaged parts. Before further use of the machine, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced. 17. Provide for adequate space surrounding work area and non-glare, ove

Leave enough space around the work area for loading and off-loading stock and general maintenance. The stock feeder and the auxiliary machine to which you are mounting it should both be disconnected from power during installation. 1. Determine the mounting location for the stand. Keep in mind the overall length of the horizontal arm on the stand (27-1/2”) so that there will be enough adjustment when the Stock Feeder is mounted. IMPORTANT: Locate the stand so that you will not drill through any r