14 Miter Gauge (optional accessory) ................................................................................................... 14 Tilting the Table............................................................................................................................. 15 Height Scale Adjustment................................................................................................................ 15 Changing Blades.............................................................

The second inlet duct on the side of the system is available for connecting another grinding machine. In areas with limited space, this may be the most desirable option. The dust collection system features a chip drawer into which grinding debris is collected. The dust collection system has a filter at the rear to filter out remaining grinding debris. The system has a removable top that provides access for cleaning and maintenance. The system is controlled by an ON/OFF toggle switch on the motor

M-0460286 Ph.: 800-274-6848 Revision E3 11/2010 Copyright © 2010 Walter Meier (Manufacturing), Inc. Warranty and Service Walter Meier (Manufacturing), Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the United States can give you quick service. In most cases, any of these Walter Meier Authorized Service Centers can authorize warranty repair, assist you in obtaining parts, or perform routine maintenance a

5507796 Revision C2 09/04 Copyright © WMH Tool Group Table of Contents Cover Page .........................................................................................................................................1 General Specifications.........................................................................................................................4 Operating Precautions ................................................................................................................

Press ABS button (no longer than 3 seconds) to switch to relative mode. “INC” will appear on the display. The value shown is in relative mode; it is an incremental position that can be zeroed at any point and determines not the thickness of a board, but how much material will be removed from a board. Moving the table up and down will now display relative measurement until you press ABS again to go back to absolute. IMPORTANT: Always place the digital display in relative (“INC”) mode before turni

Then set the ON/OFF switch to OFF. Figure 4: Operating Controls (Model 4126AC) Speed Display(RPM) STOP Button FWD (Forward) Button On/OffSwitch Up Down 9 Typical Uses for the Square Wheel Belt Grinder Flat or angular stock — Platen setting is the perfect angle for high speed, precision, flat and level grinding of tools, knives, plastics, and other materials. The platen allows working to very close tolerances. An adjustable work rest is standard on all models. Shaping — For grinding and finishing