RESIDENTIAL & COMMERCIAL VERSATILITY The 570Z is ideal for small landscape areas and intricate designs. The PR and PRX models are ideal for applications with high or varying operating pressure, including long lines and slopes. Seven distinct pop-up sprinkler bodies and 108 interchangeable nozzles provide unlimited design and flexibility. RELIABILITY With productivity enhancing features such as the patented X-Flow technology, water loss is minimized from broken or damaged nozzles and repairs can

Some of these features are listed below. Model 69X-06-XX Specifications • 78 ft. – 108 ft. Radius • Pop-Up Nozzle and Cap -7.8 in. •11.2 in. NPT Female Thread Inlet • Recommended Operating Pressure: 60 – 100 PSI • Maximum Pressure: 150 PSI • Electric Models: – Solenoid - 24 VAC – Inrush Current - .40 Amps – Holding Current - .235 Amps • Dimensions: – Cap Diameter - 71.2 in. – Flange Diameter - 10 in. – Height - 16 in. Model 69X-01-XX Model 69X-02-XX Features • Positive Spring Retraction -Pulls n

2. Connect water supply to either bottom or side inlet.* 3. Seal unused inlet with plug included. 4. Fill hole around sprinkler with gravel, covered by layer of soil. *In cold climates, protect sprinkler from freeze damage by installing a Toro Drain valve (sold separately, Model 53740) to bottom inlet. For new installations, avoid dry spots and areas of over-watering by spacing sprinklers so their spray patterns overlap. Use the guidelines in the accompanying chart and position sprinklers as sho

Also, place the Sensor Bypass switch in the Active position for sensor-controlled operation. • Remove the valve common wire(s) from the valve common wire terminal and join to one RainSensor wire lead using a twist-on wire connector. Attach the remaining RainSensor wire lead to the valve common terminal. Timer with Sensor terminals, with or without pump start/ master valve: A Sensor Bypass Switch To Valves Common Wire From Valves Timer without Sensor terminals or pump start/ master valve: B Irrig

The station will shut off when the runtime counts down (or is adjusted down) to 00.0 minutes. Each station will operate in sequence for the selected runtime. Note: To terminate operation, either reduce the station runtime to 00.0 or turn the Function Selector knob momentarily to the OFF position. 63 The Run Function RUN is the Function dial position for normal controller operations. However, automatic controller operation will occur when the Function Selector knob is in any position other th