Bullere ind PdiiI Ilfatrrs PUMP-Rec-08 Rev C PUMP RECOMMENDATION FOR COPPER-FIN II 401-751 POOL HEATER Pump Specifications Part No. HorsePower Flanges Valute Material Flange Material Vendor Vendor Product Series Orientation ARM3044PABTE 1/4 2" Bronze Bronze Armstrong LS45 Horizontal Installation Specifications Pump Recommended for Model Numbers Maximum GPM Based on Installation Type Copper-Fin II Pool Htr, CP(N,L) 401-751 55 GPM Single Pool Heater piped Primary/Secondary to Pool Loop AR

If installing in attic space, ensure that the instruments do not overheat. ¦ The pressure / temperature operating parameters must be within the prescribed limits. Excess operating temperatures should be avoided for continuous operation. ¦ The provisions stated in DIN EN 12976-1 should be observed when installing solar systems. ¦ The expansion tank should be regularly checked according to DIN 4807. ¦ Solar systems should be grounded to protect against lightning. ¦ The system’s electrical connecti

PING) 24" 24" 24" 24" 24" 24" 24" 24" TOP 3" 3" 3" 3" 3" 3" 3" 3" VENTING SIZE 6” 8" 8" 10" 12" 12" 14" 14" VENT CATEGORY I I I I I I I I VENT MATERIAL B-VENT B-VENT B-VENT B-VENT B-VENT B-VENT B-VENT B-VENT MAXIMUM DRAFT -0.08" w.c. -0.08" w.c. -0.08" w.c. -0.08" w.c. -0.08" w.c. -0.08" w.c. -0.08" w.c. -0.08" w.c. MINIMUM DRAFT -0.01" w.c. -0.01" w.c. -0.01" w.c. -0.01" w.c. -0.01" w.c. -0.01" w.c. -0.01" w.c. -0.01" w.c. * Minimum flow rate and head loss are based on a 40°F te

O. Smith Water Products Co. You should thoroughly read and understand this manual before installation and/or operation of this boiler. Please pay particular attention to the important safety and operating instructions as well as the WARNINGS and CAUTIONS. CONTENTS PAGE ROUGH-IN DIMENSIONS/CAPACITIES ............. 2 - 3 FOREWORD ..................................................... 4 - 5 FEATURES/CONTROLS ................................... 5 - 6 INSTALLATION INSTRUCTIONS ................... 6 -

The time range of this parameter is 10 minutes to 240 minutes. The default value is 30 minutes. F: Outdoor air reset Outdoor air shutdown When the outdoor air shutdown rises above this point, the control will block all SH demands (DHW demands will still be active). This parameter can be changed by the user or the installer by accessing parameter F5. The temperature range of this parameter is 0°F to 120°F. The default value is 80°F. Outdoor air shutdown differential The outdoor air shutdown diffe

SL-PS Installation & Operation Manual 3 Technology, installation and commissioning Clamp ring screw connections ¦ Cut the copper pipe to length and deburr. ¦ First, slide the clamp ring nut over the pipe, then slide the clamp ring. ¦ Insert the prepared pipe into the screw connection until its stop is reached. ¦ Tighten clamp ring nut by hand. ¦ Use open-ended wrench to tighten clamp ring screw connection (approx. 33 Ft lb), re-tighten if necessary. ¦ When tightening the clamp ring screw connect