9. All of the information in STAGE 1 has now been entered. If ENTER / REVIEW is pressed again, STAGE 2 light turns on. Review STAGE 2 following the same procedure as above. Continue pressing ENTER / REVIEW to review all of the individual parameters in STAGE 2, 3, or 4. NOTE: NIGHT TIME (DELAY START) appears only at the very beginning of STAGE 1. 13 OPERATION EDIT WHILE A PROGRAM IS RUNNING (Figure 1) 1. To identify which program is running, press PROGRAM NUMBER. NOTE: The program number cannot b

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

THE OUTSIDE OF THE CARD IS THE SIZE OF THE BEZEL -USE IT TO POSITION AND CUT THE HOLE. Please Note the molded bezel that mounts in front of this frame measures 11" x 12-1/2',' so allow at least 1" clearance around the hole you cut to allow for the bezel. 1. Cut hole and locate cable. 2. Locate the thicker, long side of the frame onto the upper edge of hole, swing the frame into the hole and allow the frame to drop down and locate onto the lower long edge of hole. Tighten 4 x S/T screws to cla