Log:

PAC Car Amplifier

Downloads : 16 Arquivo Tamanho: 397 kb    Fabricante : PAC  
Categoria : Avtousiliteli

Pacific Accessory Corporation - Santa Ana, CA 92705 866-931-8021 • 06-29-10 TATO JBL Amplifier Turn-On Interface for Toyota CANbus Vehicles The TATO is designed to control the power and audio levels of the factory installed JBL amplifier allowing the OEM radio to be removed and replaced with an aftermarket stereo. Installation: Note: BEFORE REMOVING THE FACTORY RADIO: BALANCE AND FADE IT TO THE CENTER, TURN THE RADIO UP TO AT LEAST 3/4 VOLUME, TURN THE RADIO OFF, TURN THE IGNITION OFF & THEN PRO

PAC C2R-VW2

Downloads : 6 Arquivo Tamanho: 292 kb    Fabricante : PAC  
Categoria : Unidade

Output (1 amp) Red / White P.B. Output (-) Purple / White VSS Output (Pulse) Orange / White Illum. Output (+) Green Reverse Output (+) White / Green SWC Output Radio Specific Steering Wheel Control Interface (Sold Separately) Program SWC Interface for Version 2. Installation Notes: For the most current and up-to-date application guide please visit 1. Vehicles with or without a factory amplifier: Connect the aftermarket radio’s front and rear speaker wires to the 16 pin plug. 2. The acc

PAC C2R-CHY4

Downloads : 48 Arquivo Tamanho: 297 kb    Fabricante : PAC  
Categoria : Outros acessórios para a casa

Output (1 amp) Red / White P.B. Output (-) Purple / White VSS Output (Pulse) Orange / White Illum. Output (+) Green Reverse Output (+) White / Green SWC Output Blue / White Amp Turn On Input C Radio Specific Steering Wheel Control Interface (Sold Separately) Program SWC Interface for Version 2. Installation Notes: 1. Only one of the two provided radio harnesses will be used. Remove the factory installed radio to determine the correct harness for your particular vehicle. 2. Vehicles wi

PAC AAI-NIS2

Downloads : 17 Arquivo Tamanho: 203 kb    Fabricante : PAC  
Categoria : Outros acessórios para a casa

Works with or without factory satellite receiver installed. Pacific Accessory Corporation Installation: The AAI-NIS2 plugs into the back of the factory radio. If the factory SAT radio tuner is present and not currently serviced, the AAI-NIS2 interface must be used in the “No SAT” mode. The original 12 pin SAT connector should NOT be connected to the AAI-NIS2 interface. It is highly recommended that you disconnect the negative battery cable prior to installing the AAI-NIS2. Do not turn on the veh





categorias