Read and follow all instructions before using this appliance to prevent the potential risk of fire, electric shock, personal injury or damage to the appliance as a result of improper usage of the appliance. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Electrical Specifications: 115 volts 12.0 amps 1265 watts Copyright 2010 Lloyds Equipment, Inc. All rights reserved. Duplication without written consent is strictly prohibited. Cal Flame

This Owner’s Manual is for barbecues manufactured after May 19, 2004 Due to continuous improvement programs, all models, operation, and/or specifications are subject to change without prior notice. LTR17006331 Owner’s Manual Table of Contents Table of Contents Benefits of Owning a Cal Flame Barbecue ..........................................................................................2 Safety Precautions.........................................................................................

If you are installing your spa with any type of structure on the outside, such as a gazebo, remember to allow access for service. It is always best to design special installations so that the spa can still be accessed. Outdoor equipment pack (in-ground spas only) The Designer Spa series requires an external equipment pack. When locating the outdoor equipment pack, you will want to consider the following: The equipment pack must be located within a maximum of 15 feet • from the spa. Ensure the eq

All rights reserved. Duplication without written consent is strictly prohibited. Cal Spas® is a registered trademark. Due to continuous improvement programs, all models, operation, and/or specifications are subject to change without prior notice. LTR20091024, Rev. A 12/15/08 CONTACT INFORMATION For customer service, please contact your authorized dealer immediately. If you need additional information and/or assistance, please contact: LMS Customer Service Department 1462 East Ninth Street Pomona

The sand bed is to level the spa shell and provide a perfect support base with no voids when the spa is lowered into the hole. Your excavation should be approximately one foot longer and one foot wider than the spa shell. This will allow for a six inch over dig all the way around the spa once it is in place. Additional hand excavation will be required to insure the skimmer will fit in the excavation when attached to the spa. Sand or rock dust must be used to bed the shell into the excavation and

To test the GFCI breaker follow these instructions (spa should be operating): Press the TEST button on the GFCI. The GFCI will trip and the spa will 1. shut off. Reset the GFCI breaker by switching the breaker to the full OFF posi2. tion, wait a moment, then turn the breaker back on. The spa should have power again. Configuring the 6300 Control System The 6300 control system requires higher power than other 240V systems. Dip switch #10 is factory set in the ON position. This causes the heater to

Designer Spa Specifications DIJ401 and DIJ405: Equipment pack weight = 250 lbs. DIJ407: Equipment pack weight = 300 lbs. 2.5 HP heat pump 4 HP swim pump Note: Equipment pack cannot exceed 15 feet from spa. In-Ground Plumbing Connections IMPORTANT! Always check local codes prior to any in-ground spa installation. Once the spa and equipment are properly located, you will want to lay out the plumbing run. Trenches should be deep and wide enough to allow all pipes to be buried below the frost line a

Topside Control Panel and Temp Sensor: 1” line that connects to the bottom of the control box located on the equipment pack. Electrical and Electronic Connection Remote Equipment Topside Control Panel The next few steps to complete the installation should be performed along with installation of the temperature sensor and 12V spa light wiring (if applicable). All of these components are generally installed using the same conduit. Locate the topside control panel 1. extension loom in the control b

If you are pouring a regular deck up to the spas coping, then the top of the coping should be 4” above the surrounding area. In either event, it is recommended to dig out an area around the spa exposing the flange of the coping and just under it. This is important, as concrete should be packed under and over the flange of the spa, as the deck is poured. This will lock the spa into the concrete and provide for a much stronger bond of the spa to the deck. It will also eliminate cracking of the dec

C om THE PERFECT BARBECUE CART HAS NEVER BEEN MORE CONVENIENT 197WWW . CA lsp A s. C om THE PERFECT BARBECUE CART HAS NEVER BEEN MORE CONVENIENT 197 For the outdoor enthusiast, there is no greater joy than cooking outside. Whether it’s your home backyard or your apartment balcony, Cal Flame offers the perfect barbecue cart. These professional-grade grills are crafted with the quality that discerning chefs require and mobility that many people demand. Whether your cooking preference is charcoal,