© 2007 Dacor, all rights reserved. Table of Contents Table of Contents Before You Begin... ........................................................... 1 Important Safety Instructions .......................................... 1 General Safety Precautions ............................................. 2 Installation Specifications................................................3 Verifying the Package Contents....................................... 3 Installation Planning...........................

Two staggered 45° angles are better than one 90°. • Keep turns as far away from the hood exhaust as possible, with as much space between each bend as possible. • For best performance, use round duct instead of rectangular, especially when elbows are required. • If multiple elbows are used, try to keep a minimum of 24” (61 cm) of straight duct between them. • Avoid “S” or “back to back” configurations of adjacent elbows. • In regions where the weather gets extremely cold, thermal breaks, such as

Additional space may need to be added for appearance. Specifications are subject to change without notice. See installation instructions for additional details. CI.24 Web: Corporate Phone: 800-793-0093

When doing so, avoid having any hot embers, sparks or open flames in the immediate vicinity. We recommend leaving the cooked food to cool in the oven with the door shut for approx. 10-15 minutes after switching off the oven. Operating Instructions • Repairs to the appliance may only be performed by qualified service engineers. Improper repairs can give rise to significant hazards. If your appliance needs repairing, please contact our Customer Service or your specialist dealer. • In the case of t

Do not install a damaged or incomplete appliance. Hood assembly with filter(s) Chimney assembly (2 piece) Mounting bracket Blower exhaust cowling (2 blower units only) Framework assembly (2 piece) Mounting and assembly hardware Use and care manual Make sure you have everything necessary for proper installation before proceeding. A B C D E F G A B C D E F G preparing for insTallaTion preparing for insTallaTion WARNING • • • • The electrical service to the range hood should be installed only by a

Detergent will harden if it sits too long. • Store dry detergent in a cool dry place to prevent caking. • Use a liquid rinse aid for best results (See page 15). • If the detergent dispenser lid is closed, press the release button to open it. • The detergent dispenser has two compartments: The smaller pre-wash compartment, and the main wash compartment. • The pre-wash compartment empties into the dishwasher when the door is closed. The main wash compartment releases detergent automatically during

Use of a soft cloth reduces the risk of scratching. If the cloth is wet ensure that a dry soft cloth is used to wipe down the surface again reducing the risk of any surface rust appearing. Glass Surface The inlay glass panel can be cleaned using warm soapy water. Ensure the cloth is well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning. Cleaning grease filters The mesh filters can be cleaned either by hand or in the dishwasher. After cleaning ensu

102 D Cooker Hood Installation and Operating Instructions Contents Drawings.............................................................................3-4 General...................................................................................5 Notes prior to installation....................................................6 Electrical connection............................................................6 Preparation for installation..................................................9

. There shall be a minimum clearance of 2 inches (51mm) between the floor of the LP-gas cylinder enclosure and the ground. • The design of the outdoor cooking enclosure must allow the LP-gas cylinder to be connected, disconnected and the connections inspected and tested outside the cylinder enclosure. • Connections which may be disturbed when installing the cylinder in the enclosure can be leak tested inside the enclosure. • Internal mounting means shall be provided on the outdoor gas grill for

Good drainage provides the best drying. It is not necessary to rinse items before loading them. • Place dinner plates, side plates, serving dishes and saucepans on the bottom rack. • Load crystal and glass so that it does not knock together during the wash cycle. Use the lowest wash temperature and shortest wash cycle possible. Do not heat dry crystal. • To minimize noise, do not allow pots and pans to touch. Also keep large items from touching the sides of your dishwasher. Operating Your Dishwa